- ページ 7

オフィス機器 Formax FD 90のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Formax FD 90 11 ページ。 Rotary perforators
Formax FD 90 にも：取扱説明書 (11 ページ)

INSTALLATION AND OPERATION

After unpacking the FD 90, place it on a solid surface and slide the infeed table into the machine and secure with enclosed

screws. Connect the male part of the cable into the female part of the connector that is located on the inside of the left

side cover of the machine. Connect the power cord into the FD 90 and plug into an appropriate electrical outlet. Do not

turn on power until adjustments have been made.

Push the feed tray down until the lever (13) locks to secure the table in the open position. Set the side guides (8) to the width

of the paper being used and secure the position of of the side guides using the thumb screws (14). When feeding small-size

sheets, remember to align the paper to the center of the table. The center of the sheet should always make contact with the

center of the rubber singulator pad (15). To make fine adjustments to the side guides (± 5mm), use the screw adjustment

knob (16).

The squareness of the feed table to the infeed can be adjusted using the skew adjustment knob (17). Check the ideal center

position by aligning the cross position mark (18). The feed table extension can be used to support large paper sheets (9).

Note: Sheets weighing 180 g/m² and more must be inserted one at a time.

MyBinding.com

5500 NE Moore Court

Hillsboro, OR 97124

Toll Free: 1-800-944-4573

Local: 503-640-5920

Infeed table

Electrical input

Connector input