- ページ 5

換気フード Ancona Arca 30のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Ancona Arca 30 6 ページ。

WALL MOUNTED RANGE HOOD INSTALLATION (cont'd)

Note: Range hoods pictured in this manual are generic to represent all models.

 Make the holes that correspond with the centre of the hob, so that the lower

part of the hood, which is to be assembled afterwards, is arranged at least 61

cm (24") from the stove top for electric models and at least 76 cm (30") for

gas models (See Pic 9)

 Installing range hood hook: Drill 3 holes in a suitable place according to

size of hook, use screws to fix the hook on the wall;

 Installing chimney bracket: drill 2 holes according to size of inside chimney

bracket in a suitable position, the position of bracket should be flush with the

top of the outside chimney. (See Pic 10)

 Fix the damper on the top vent of hood with 4 screws (see pic 4), then install

the ducting pipes onto the damper. (See Pic 11) - If the ventilation system is

equipped with an external air duct with a different diameter, apply a

reduction fitting. However for maximum performance and safety 6" Ø

ducting is recommended.

 Use 2 screws to fix two chimneys together with the outside chimney bracket,

make sure inside chimney is moving freely. (See Pic 12)

 Install the chimneys on the hood. (See Pic 13)

 Fix the chimney and hood together with two screws. (See Pic 14) – this step

is just for the models which have holes on bottom of outside chimney.

 Hang the hood on the range hood hook. (See Pic 15)

 Pull out the inside chimney and adjust height according to the position of

inside chimney bracket on the wall, then fix the inside chimney on the

bracket with two screws. (See Pic 16)