- ページ 4

産業機器 Formax Greenwave 410のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Formax Greenwave 410 4 ページ。 Cardboard perforator

Operation

1. If the cardboard to be processed is wider than

the Greenwave 410 infeed (16"), the excess will

be trimmed automatically (Fig. 3).

2. To choose a custom width, adjust the cutting

guide based on the side trim measuring scale

(Fig. 1). Loosen the knob, slide the guide to the

chosen width, then tighten the knob.

3. Set main switch to the "START/-" position (Fig.

2). The perforating blades will begin moving.

4. Feed the cardboard into the infeed slot (Fig. 3).

The cardboard will be perforated and exit

through the rear of the machine (inset).

5. To turn off the perforating mechanism, set the

main switch to the "STOP/O" position (Fig. 2).

6. In case of a jam, press "REV/

switch (Fig. 2). The perforating blades will

reverse to remove the jammed material.

Check the material thickness, and re-feed if

necessary.

User Maintenance

Wipe the exterior cabinet with a damp cloth. Do NOT use solvents. A mild detergent, such as one designed for windows

or countertops works very well, and will not harm the exterior surface.

Troubleshooting

Before contacting your service provider, please check:



Is the power cord plugged in? Is the power source the correct voltage?



Is the device power switch turned on?



Is the motor overloaded? If so, allow the motor to cool down for approximately 15-20 minutes.

" on the main

Fig. 1

Fig. 2

Fig. 3

Measuring scale

Cutting guide

Excess trimmed