- ページ 7

食器洗い機 Electrolux ESF 2435のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Electrolux ESF 2435 16 ページ。

ページを印刷する

Adjusting the water softener

To prevent limescaling on the dishes and to the interior of the

dishwasher, the dishes must be washed with soft i.e. water

with low lime content.

This dishwasher is equipped with a water softener, where tap-

water which is harder then 4 °d (german degree) is descaled

with special salt.

Adjust the water softener according to the table below for the

water hardness level for your area.

Water hardness level

°d

> 24

18 - 24

12 - 18

4 - 12

below 4

In the following settings the dishwasher must be switched off and all programmes completed.

See chapter "Using the appliance" for information on how to complete the programme.

1. Press the On/Off button.

2. Press the combination buttons simultaneously

and hold them pressed in. When the ﬁrst three

programme indicator lamps starts to ﬂash, you

can let go of the buttons.

3. Press the water softener button once. The lamps

for the water softener and for the ended pro-

gramme cycle starts to ﬂash.

- The number of ﬂashes for the ended programme

cycle are equivalent with the set water hardness

level.

- This sequence of ﬂashes is repeated several

times after a few seconds pause.

4. The water hardness level is raised by 1 step

every time you press the water softener button.

After hardness level 5 comes hardness level 1.

5. Press the On/Off button when the required water

hardness level is selected. This saves the selection.

If the setting 1 is chosen, the salt indicator lamp

is not lit.

1) german degree of measurement for the water

hardness

2) millimol, internationel unit for water hardness

*) factory setting

mmol/l

> 4,2

3,2 - 4,2

2,1 - 3,2

0,7 - 2,1

below 0,7

- 7 -

Contact your local Water Authority to ﬁnd the

exact water hardness level for your area.

The water softener has 5 settings:

Setting on the

water softener

no salt is needed

Number of

light ﬂashes