- ページ 7
食器洗い機 Electrolux ESF 4101のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Electrolux ESF 4101 20 ページ。
ページを印刷する
Prior to using for the first time
Before using your dishwasher for the first time:
1. Ensure that the electrical and water connections comply
with the installation instructions
2. Remove all packaging from inside the appliance
3. Set the water softener
4. Pour 1 litre of water inside the salt container and then fill
with salt
5. Fill the rinse aid dispenser
The water softener
The dishwasher is equipped with a water softener designed to
remove minerals and salts from the water supply, which would
have a detrimental or adverse effect on the operation of the
appliance.
The higher the content of these salts, the harder your water is.
Water hardness is measured in equivalent scales, German
degrees, French degrees and mmol/l (millimol per litre).
The softener should be adjusted according to the hardness of
the water in your area. Your local Water Authority can advise
you on the hardness of the water in your area.
Setting the water softener
1. Open the dishwasher door.
2. Remove the lower basket from the dishwasher.
3. Turn the water hardness switch until the required level (see
table) corresponds with the marker .
4. Replace the lower basket.
The dishwasher is factory set
at position 2.
AA08
Water hardness
German
French
(millimol per litre,
degrees
degrees
international unit for
(°dH)
(°TH)
the hardness of water)
46 - 50
81 - 90
35 - 45
61 - 80
23 - 34
41 - 60
12 - 22
21 - 40
4 - 11
8 - 20
< 4
< 8
Filling with salt
Only use salt specifically designed for use in
dishwashers.
All other types of salt not specifically designed for use in
a dishwasher, especially table salt, will damage the water
softener.
Only fill with salt just before starting one of the complete
washing programmes.
This will prevent any grains of salt or salty water, which
may have been spilt, remaining on the bottom of the
machine for any period of time, which may cause
corrosion.
To fill:
1. Open the door, remove the lower basket and unscrew the
cap of the salt container by turning it anticlockwise.
2. Pour 1 litre of water inside the container (this is necessary
only before filling with salt for the first time).
3. Using the funnel provided,
pour in the salt until the
container is full.
4. Replace the cap making
sure that there is no trace
of salt on the screw
thread or on the gasket.
5. Screw on the cap tightly
turning it clockwise until it
stops with a click.
The salt container will require topping up periodically.
The salt cap has a refill
indicator window in the
centre. A green float is
clearly visible when there is
salt inside the container and
almost disappears when the
salt has finished reminding
you to add salt.
Do not worry if water over flows from the unit when filling with
salt, this is quite normal.
in mmol/l
Range
8,3 - 8,9
IV
6,3 - 8,2
IV
4,0 - 6,2
IV
2,0 - 3,9
III
0,7 - 1,9
I/II
< 0,7
I
7
SR14
SR22
Setting
Use of
of the
salt
water
softener
level 5
yes
yes
level 4
yes
level 3
yes
level 2
yes
level 1
no
level 1