ページを印刷する
Dust cup emptying
EN
1. When the dust reach to the 1/3 level in the dust-cup, it means dust-cup is full.
At this moment, dust-cup should be emptied or the filter should be washed.
2. Open the dust-cup as showing in the picture.
FI
EE
LV
LT
RU
Maintenance
1. When the Plastic-filter is full of dust, it should be washed.
2. Don't wash the filter in the washing machine or dry it with electrical heater.
Clean the sponge filter
1. Take out the filter when it's dirty.
2. Clean it in the water. Dry it naturally before next use.
3. These parts should clean each time after you empty the trash as following.
Otherwise the dust will block the air inlet and reduce the suction power and burned motor.
4. When lock the dust container cover, the mark should be in a line, otherwise the dust will enter into motor and burn motor.
5. When install the dust container into vacuum cleaner body, we shall press the dust container until there is "CLICK" sound,
then it is 100% fixed. Otherwise there will be dust leakage and reduce suction power.
6. This vacuum cleaner is for dry cleaning only. Do not fill the water into the dust container. Dust container and filters must
be dry before installing it on vacuum cleaner. You can only wash the dust container and filters after disconnecting it from
the vacuum cleaner. Dry the filters and dust container naturally before next use.
Waste Management:
Product is classed as Electrical or Electronic equipment and should not be disposed with other household or commercial
waste at the end of its useful life. The Waste of Electrical and Electronic Equipment (WEEE) Directive (2002/96/EC) has
been put in place to recycle products using best available recovery and recycling techniques to minimise the impact on the
environment, treat any hazardous substances and avoid the increasing landfill. Contact local authorities for information
on the correct disposal of Electrical or Electronic equipment.
4