ページを印刷するMeasurement With Storing Data
1. Place the cuff on the arm (preferably the left arm).
Sit quietly during measurement.
2. Press the
START
The buzzer sounds and the average blood pressures
and the WHO classification and last data number are
displayed briefly.
When the " 0 " is flashing, the device is ready for
measurement. If the
has some air trapped in it. Press the exhaust valve
button until the
3. Pressurize the cuff by squeezing the rubber bulb.
A pressure bar indicator and the current pressure are
displayed.
Stop squeezing the rubber bulb when the
disappears.
Note: If you want to stop inflation at any time, stop
squeezing the rubber bulb and press the
exhaust valve button to expel the air from the
cuff.
4. When
inflation
automatically and the buzzer sounds and the
(heart mark) blinks, indicating that the measurement
is in progress. Once the pulse is detected, the mark
flashes and the buzzer sounds with each pulse beat.
5. When the measurement is complete,
the buzzer sounds and the
displayed. The systolic and diastolic
pressure readings and pulse rate are
displayed and stored.
6. Press the exhaust valve button to
completely release air from the cuff.
When a measurement is made with
insufficient pressure, the
displayed. Re-pressurize the cuff. Stop
squeezing the rubber bulb when the
mark disappears.
When a measurement is made with an
erratic pulse or in a very noisy
environment,
7. Turning the power off
Press the
START
The device will be in standby mode.
8. Subsequent measurements
Measurements
button.
mark is displayed, the cuff
mark is displayed.
is
complete,
deflation
mark is
mark will be
will display.
button to turn the power off.
English 8
mark
starts