自動車アクセサリー FormFit HD 11B 04のPDF クイックマニュアルをオンラインで閲覧またはダウンロードできます。FormFit HD 11B 04 2 ページ。 Mazda 6 2004-

ページを印刷する

FORM FIT

HOOD PROTECTOR

Mazda 6 2004 -

Thank you for purchasing a form fit hood protector.

Care Instructions

Clean the protector with a mild soap and water solution or plastic cleaner only.

Periodically check to make sure all the hardware is in place and the protector is secure.

Attention!

Do not use chemicals or solvents. Avoid using automatic car washes. Do not pull on the

protector when opening or closing the hood.

Hardware Kit

x 1

x 2

x 4

Tools Required

Installation Instruction

1. Be sure that the hood is clean and dry inside and out. Release the hood, but do not open it.

2. Wipe the area shown below where the mounting pedestal will attach to the hood with the adhesion

promoter, to break the seal and release the primer into the brush, crush the tube at the black dot. Allow to

dry.

3. Peel the protective backing from the tape on the pedestal and attach it to the hood open and down. See

Illustration #1.Press down firmly on mounting pedestal to make sure that is properly adhered to the hood.

4. Position the protector on the hood by engaging the hook from the pedestal installed on the protector with

the pedestal installed on the hood. See Illustration #1.

5. Make sure the protector is centered. Raise the hood of the vehicle without disturbing the hood protector

placement. Attach the anti-abrasion film pads to the hood in line with the holes in the leading edge of the

protector. Fold the pads in half over the hood edge to cover at least ½" of the underside of the hood. See

Illustration #1 & 2.

6. Slide the "C" clips on the hood in line with the holes in the protector. Be sure that the "C" clips are well

seated against the hood; it may be necessary to tap on the clips. See Illustration #1 & 2.

7. Be sure that the hole in the top of the clips lines up with the hole in the protector, then tighten the

3/8" screws, through the protector and into the top of the "C" clips. Do not over tighten. See Illustration

#2.

8. Make sure all the clips are well seated against the hood. Tighten the #4 x 3/16'' screws in the back of the

"C" clips. See Illustration #2.

9. On some vehicles it may be necessary to adjust the hood bumpers and/or latch for proper clearance.

Note: Do not pull on the protector when opening or closing the hood.

Illustration #1 : Hardware Installation

Pedestal Clip

"C" Clips

Protector

Made in Canada

HD 11B 04

# 6 x 3/8''

# 4 x 3/16''

Screws

x 4

Illustration #2 : Clip Configuration

Hood

Pedestal Clips

Rev0.030416