- ページ 10
掃除機 Dreame H12 SのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dreame H12 S 13 ページ。 Wet and dry vacuum
ページを印刷する
Care & Maintenance
Cleaning the Filter
* Replace it every 3 to 6 months.
1. Remove the filter from the top of the
used water tank.
Cleaning the Tube
Remove the used water tank, wipe it with a damp cloth to clean out the tube before use.
16
2. If the filter is dirty, rinse it with clean
water and dry it completely before use.
FAQ
Error
Possible Cause
The handle is not installed in
place.
The vacuum is out of battery or
its battery level is low.
The vacuum is in the upright
The vacuum
position.
does not work.
The brush roller is entangled
by hairs and unable to rotate.
The used water tank is full.
The filter is clogged.
The brush roller, filter, or used
water tank is not installed in
place.
The suction
power of the
vacuum is weak.
The brush roller is entangled
by hairs.
There are some foreign objects
in the tube or the tube is
blocked.
Too much dirty water in the
used water tank.
The motor
is making a
strange noise.
The suction inlet is blocked.
The power adapter is not
plugged into the electrical
The battery
outlet.
status indicator
does not light up
The power adapter is not
while charging.
connected to the charging
base.
Solution
Re-install the handle.
Fully charge its battery
before use.
Recline the vacuum
backwards.
Clean the brush roller.
Empty the used water tank.
Clean the filter.
Reinstall the brush roller,
filter, or used water tank
before use.
Refer to the maintenance
guide [Cleaning the Brush
Roller] section.
Clean the tube.
Empty the used water tank.
Clear any blockage in the
suction inlet.
Make sure the power
adapter is plugged in.
Make sure they are
connected.
17