- ページ 15

レーダー Carmanah MX SeriesのPDF インストールマニュアルをオンラインで閲覧またはダウンロードできます。Carmanah MX Series 20 ページ。 Radar detection kit
Carmanah MX Series にも：インストールマニュアル (2 ページ), インストールマニュアル (2 ページ), 交換マニュアル (4 ページ), 交換マニュアル (2 ページ), 交換マニュアル (4 ページ), 交換マニュアル (2 ページ)

4.4

Adjusting Trigger Output Configuration

Under the "DR600 Setup," "Hardware & IO Config" tab are settings that control the system's activation behavior:

Trigger Event: this setting changes the conditions under which an activation of the connected Carmanah MX

system occurs:

None: no activations will occur.

•

Default: Displayed Target Above Speed Limit (default setting): Carmanah MX system activated

•

when vehicle detected above configured Speed Limit on "Detection & Units" tab.

Displayed Target Below Speed Limit: Carmanah MX system activated when vehicle detected

•

below configured Speed Limit on "Detection & Units" tab.

•

Any Displayed Target: Carmanah MX system activated whenever a vehicle is detected, regardless

of speed.

Trigger Direction: this setting changes whether incoming vehicles, outgoing vehicles, or both will trigger the

connected Carmanah MX system. Default setting is Incoming.

Click on "Save Changes" to save the changes to the radar module, or "Close" to disconnect from

the radar module without saving.

Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |

RADAR DETECTION KIT INSTALL GUIDE

carmanah.com

LEVEL 4