- ページ 10

音楽ミキサー ATI Audio MX100CのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。ATI Audio MX100C 17 ページ。 Mono output mixers and input expander

CUE/ MONITOR HEADPHONE LEVEL

The CUE/MONITOR level adjust trimmer on the MX101 (R74) is factory set for a

comfortable listening level at a director's cue input level of -10dBu (.25Vrms) but

can be adjusted as required.

MOUNTING

You may rack mount one, two, or three units across in a standard EIA 19" rack

requiring only 1-3/4" of vertical space. Rack Mount Shelf Assembly P/N 21075-

501 mounts one, two or three units. Use 1/3 RU Filler Panels, P/N 21097-501, to

fill any unused space on the 21075-501 Rack Shelf.

Single desk mounting kits consist of a pair of angled base plates that mount un-

der the lower front and rear cover screws of a single unit to raise and to tilt it for

easy use. In addition, one or more sets of vertical stacking plates, mounting to

the upper front and rear cover screws of the bottom unit, allow multiple units to

be stacked. Several units can be desk mounted side by side and even stacked

side-by-side using horizontal joiner kits together with mounting base and stacker

kits. P/N 20617-501 is the angled base kit. P/N 20617-502 is the base plus one

stacker kit (two high). P/N 20617-503 is the base plus two stackers (three high).

P/N 20617- 504 is the stacker kit by itself and P/N 20617-505 is a horizontal join-

er kit.

Detailed instructions for mounting the protection plates and battery pack slides

are included with the PROK-1 and ABAG-1 if they have not been pre-assembled

to the mixer.

AUDIO CONNECTIONS

XLR type inputs and outputs are wired with pin 2 as HI and pin 3 as LOW. Pin 1

of all input connectors is grounded and is the cable shield and DC return connec-

tion for phantom microphone power. Pin 1 of the output connector is grounded.

Active balanced outputs require a reference ground connection to the receiving

device for proper operation. This ground can be provided by the rack frame or a

studio buss connection but is preferably carried through by the output cable

shield.

Hum and noise performance of the XP100 can be degraded by poor DC ground

connections between it and the MX100. Use of the recommended rack and desk

mounting kits will assure a good ground connection between units by firmly

ATI Audio Inc.

■ Tel: 856-626-3480

Fax: 856-504-0220

www.

audio.com

■