- ページ 15

自転車アクセサリー Formula THIRTYFIVE QR15のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Formula THIRTYFIVE QR15 18 ページ。 35-29” fork

ページを印刷する

- Apply medium strength threadlocker

around the thread of screws (4-5). Ap-

ply grease to the o-rings on the screws.

- Install the screws (4-5) and tighten to

6-7 Nm.

- Push the rebound knob (3) fully into

place, making sure it is secure.

- Actuate the fork a few times to verify it

works properly.

4.2

Issues - Causes - Remedies

This chart mentions some issues that may be encountered when using the fork along with the

possible causes and remedies.

WARNING: The operations listed below and accompanied by this symbol must

be carried out only by authorized service centers.

Fork not using full travel

Fork extends too quickly,

violent rebound after bum-

Steerer tends to "close"

when turning

Fork slow during extention

or "packs-up" over multiple

bumps

Bump noise during return

but without violent re-

bound

Dust seal leaks oil

Large amount of oil on up-

per tubes or oil leaks from

bottom of fork

Fork "sticky", does not work

like new

Oil loss from bottom of fork Bottom nut/screw loose O-ring

Loss of sensitivity

Oil level too high, air pressure

too high

Rebound damping insufficient

Excessive rebound damping

Dust seal damaged

Seals damaged, uppers may be

damaged

Seals dirty, fork requires main-

tenance

damaged

Slide bushings worn

Oil old

Check oil level ( )

Reduce air pressure

Increase rebound damping

Decrease rebound damping

( ) Replace dust seal

( ) Replace all seals and have

uppers inspected

( ) Replace all seals

Tighten the nut or screw

( ) Replace O-ring

( ) Replace slide bushings

( ) Change oil