- ページ 3

除湿機 Anden A210V1のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Anden A210V1 4 ページ。
Anden A210V1 にも：据付・取扱説明書 (16 ページ), クイック・スタート・マニュアル (2 ページ)

ページを印刷する

6A. WIRING AND SET-UP – MODEL A77 CONTROL

The Model A77 will measure the relative humidity and turn the dehumidifier on and off to control the humidity level to the desired setting. The

humidity setting can be adjusted from the control, while the display allows easy access and monitoring of the humidity level in the space. It is

recommended that the Model A77 be mounted at/near canopy height. Shield the Model A77 from direct exposure to HPS or LPS lighting.

NOTE: Use 18-22 AWG wire for control wiring.

Humidity can be controlled using the internal dehumidifier control, a Model A77 control, or a different external control like a thermostat.

Installing an external control eliminates the need to run the dehumidifier blower for sampling, as the control is constantly measuring the humidity

close to the canopy. When the humidity level rises above the setting, the dehumidifier is turned on.

TO INSTALL AND USE THE MODEL A77 CONTROL,

COMPLETE ALL STEPS:

1. Unplug the dehumidifier or turn off power to the circuit at the

breaker or fuse.

2. Run thermostat cable (use 18-22 AWG wire) from the Model A77 to

the control of the dehumidifier.

3. Trim about 1/4" of insulation from the end of the wires on each

end. Insert the wire into the terminals as shown in the MODEL A77

REMOTE CONTROL WIRING diagram below.

4. Restore dehumidifier power.

MODEL A77 REMOTE CONTROL WIRING

+ - A B

Remote

C/-

R/+

ODT

Sensor

MODEL A77

CONTROL

90-2490

TO SET THE DEHUMIDIFIER TO USE THE MODEL A77 CONTROL,

COMPLETE ALL STEPS:

1. With power to the dehumidifier, use the ON/OFF button to set the

dehumidifier to the OFF position.

NOTE: If the display backlight is not on, the first button press (any

button) will only turn the backlight on. Press the button a second

time to achieve the desired function.

2. Hold the MODE button on the on-board control for 3 seconds to

enter the Installer Set-up Menu.

3. The display should now read REMOTE on the left and DISABLED

on the right. Use the UP or DOWN arrow buttons to set this to

ENABLED.

4. Once the display reads REMOTE ENABLED, press the MODE button

to cycle through the other settings until the display blinks DONE

for 3 seconds.

5. Use the ON/OFF button to turn the dehumidifier ON. The display

on your unit should read REMOTE.

6. Locate the Model A77 that you just set up. On the Model A77, press

the ON button and use the arrow buttons to set your preferred

%RH setpoint. When setting up in REMOTE mode for the first

time, your dehumidifier will wait 3 minutes before starting to

dehumidify, regardless of ambient conditions.

90-1854