- ページ 5

ウインチ Andersen 18ST FSのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Andersen 18ST FS 9 ページ。
Andersen 18ST FS にも：製品マニュアル (8 ページ)

Tools required for service:

Allen key (3 mm.).

Screwdriver (small).

Winch handle.

ANDERSEN winch grease

Remove screws (1).

Remove self-tailing arm (2).

Remove drum (4).

Pull up the drive shaft (5) gently, using the winch handle.

Remove pawls (7) and springs (6).

Remove shaft (11) and pull out gearwheel (13).

Lift up ratchet gear (10) and pull it out through hole in base (14).

Clean all parts in benzine including gear teeth.

Assemble in reverse order. During assemble, by the use of a small soft brush lightly grease

all gear teeth, drive shaft, roller bearing, shafts, pawls, springs and bushings. Pawls should

only be lubricated with a very thin film of ANDERSEN WINCH GREASE. It is very important

that pawls can move freely.

IMPORTANT: When assembling the winch, check the functioning of each pawl by pushing the

pawl against the spring. The pawls should move smoothly and automatically return to their normal

position, where the pawls engage with the teeth. If the pawls do not function correctly, clean and

lubricate the pawls and gears. Check the function of the pawls again to make sure that it works

correctly. If the pawls do not work correctly replace the springs and recheck the functioning

Malfunctioning pawls may lead to unexpected failure of a loaded winch resulting in material

damage or fatal personal injury.

Service Kit No: 18 (art. no. 710018) contains service parts 18ST- 18ST FS

SERVICE INSTRUCTION

18ST ver. 1.0 – 18ST FS ver. 1.0

For current World Wide Distributor list please see: