- ページ 6

冷凍庫 Electrolux A75235-GA3のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Electrolux A75235-GA3 20 ページ。 Electrolux freezer

Control panel

Selecting Freezing or Cooling mode

The appliance can be used as a freezer or a refrigerator compartment.

• To switch over from "Freezing" to "Cooling" mode, press the Alarm reset button and

Temperature regulator - button for a few seconds.

The Temperature indicator shows FC (approx. 5 sec). The changed mode is indicated with

a beep and the DESIRED temperature shows.

• To switch over from "Cooling" to "Freezing" mode, press the Alarm reset button and

Temperature regulator - button for a few seconds.

The temperature indicator shows CF (approx. 5 sec). The changed mode is indicated with

flashing temperature, flashing alarm light, an acoustic alarm and the DESIRED temper‐

ature shows.

When switching from "Cooling" to "Freezing" mode the high temperature alarm will go on.

Refer to "High temperature alarm"

• During normal operation, the temperature indicator shows the current temperature in‐

side the appliance (ACTUAL temperature).

• During temperature adjusting operation, the temperature indicator flashes the appliance

temperature currently set (DESIRED temperature).

To operate the appliance, proceed as follows:

1. Set the required temperature by pressing the corresponding temperature regulator. The

temperature indicator flashes the DESIRED temperature.

2. Each time the temperature regulator is pressed the DESIRED temperature is adjusted

by 1 °C. The DESIRED temperature is reached within 24 hours.

Once the DESIRED temperature has been set, after a short period (approx. 5 sec.) the tem‐

perature indicator will show again the ACTUAL temperature inside the compartment. The

temperature indicator will change from flashing to continuous illumination.

For a correct storage of the food the following temperature should be set:

• -18 °C in freezing mode

• +5 °C in cooling mode

When the appliance is used as a freezer

The TURBO FROSTMATIC function accelerates the freezing of fresh food and , at the same

time, protects foodstuffs already stored from undesirable warming.

To activate the function, do these steps:

1. Press the TURBO FROSTMATIC button.

2. The TURBO FROSTMATIC indicator will light up and the Temperature indicator shows

SF (approx. 5 sec).

To deactivate the function, do these steps:

1. Press the TURBO FROSTMATIC button.

2. The TURBO FROSTMATIC indicator goes out.

The TURBO FROSTMATIC function stops automatically after about 52 hours.