- ページ 7
メディア・コンバーター Communications Specialties Scan Do Pro IIのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Communications Specialties Scan Do Pro II 15 ページ。 High resolution computer-to-video scan converter with genlock and optional sdi output (scan do pro ii/d)
ページを印刷する
REDUCING FLICKER IN
THE IMAGE:
VERTICAL FILTER:
FREEZING THE IMAGE ON
YOUR VIDEO SCREEN:
YUV/RGB COLOR SPACE:
POSITIONING THE
IMAGE ON THE
SCREEN:
Anti-Flicker: This button will activate one of four levels of flicker reduction. To
turn on the flicker filter, push the Anti-Flicker button once. This activates level one
of the filter. The green LED should illuminate, indicating that this feature is now
active.
Press the button repeatedly to cycle through levels two, three and four of the
flicker filter. The green light will remain lit for all four stages. Pushing the button a
fifth time will turn off the flicker filter and extinguish the green LED.
Try the different settings for this button to see which gives the best results for the
application you are viewing. You'll discover that depending on the type of image,
different settings provide the maximum benefit.
This button toggles the vertical fliter on and off. The LED is lit when the vertical
filter is on and off when it is off. The factory default setting is vertical filter off.
Freeze: Scan Do Pro II gives you the ability to freeze or stop the image on your
video screen without halting your computer application. When you push the Freeze
button, the images output by Scan Do Pro II will freeze and the green LED will
illuminate. (The loop-through support to your local computer monitor will remain
active.) Press the button again to deactivate the freeze feature and extinguish the LED.
While in the freeze mode, all keypad functions are still active. However, you will
not see the effects from using any other features, such as Zoom, until the Freeze
mode is turned off.
This button toggles between YUV and RGB color space. The LED is lit when in
YUV and off when in RGB. YUV is the factory default setting.
Cursor Buttons (Arrows): As TV monitors and video projectors may not always
display the image in the center of the screen, you may use the four "arrow" buttons
on the front of Scan Do Pro II to position the image up, down, left and right. The
image will move one increment each time you push the button. If you continue to
push down any of the arrow buttons, the image will begin to move continuously, first
slowly and then more quickly.
Positioning Shortcut Buttons: Pushing the following button combinations simul-
taneously will immediately position your image as follows:
IMAGE POSITION
Center image vertically
Center image horizonatally
Upper left corner
Upper right corner
Lower left corner
Lower right corner
Scan Do Pro II User's Manual
BUTTON COMBINATION
↑ ↑ ↑ ↑ ↑ and ↓ ↓ ↓ ↓ ↓
← ← ← ← ← and → → → → →
↑ ↑ ↑ ↑ ↑ and ← ← ← ← ←
↑ ↑ ↑ ↑ ↑ and → → → → →
↓ ↓ ↓ ↓ ↓ and ← ← ← ← ←
↓ ↓ ↓ ↓ ↓ and → → → → →
Page 7