- ページ 9

冷凍庫 Electrolux C335FFのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Electrolux C335FF 20 ページ。 No frost chest freezer

ページを印刷する

Installation

Position

Place the freezer horizontally on a

firm surface, resting on all wheels.

Use a wooden block or similar object

to compensate for any bumps/holes in

the surface.

The room should be dry and adequate-

ly ventilated.

Temperatures of the external environment

have an impact on the energy consump-

tion of the freezer. Therefore:

- do not place the freezer in a position

exposed to sunshine or beside a radiator

oven, or any other source of heat.

- position it where the temperature of the

environment corresponds to the

climatic classification for which the

freezer was designed.

Climatic classification Ambient temperature

From....to

+10 to +32 C

+16 to +32 C

+18 to +38 C

+18 to +43 C

If the freezer has been handled in a

vertical position it should be allowed to

stand in normal position for about 12

hours before switching it on.

Please ensure that when the appliance

is installed it is easily accessible for the

engineer in the event of a breakdown.

Electrical requirements

Before switching on, make sure that the

voltage of your electricity supply is the

same as that indicated on the rating

plate, located on the back of the cabinet.

Warning:

This appliance must be earthed.

Testing has been carried out in accordance

with EN 153 regarding the determination of

freezer capacity,energy consumption and

temperature rise time.

Description of equipment

limits

Control panel:

Electrical Connection

Any electrical work required to install this

tent person.

This appliance must be earthed.

This appliance complies with the

following EC Directives:

-73/23/EEC-Low-VoltageDirective

-89/336/EEC -EMC Directive.

Signal lamp of the control section

(green).

Signal lamp (yellow) for quick freezing.

Acoustic alarm and alarm signal lamp

(red).

Push button:

- for reset acoustic alarm

- for start quick freezing mode

- for stop quick freezing mode

appliance should be carried out by

a qualified electrician or compe-

electrolux cold 9