- ページ 3

除湿機 AIRTAK SD20のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AIRTAK SD20 9 ページ。 Refrigerated air dryers

Ambient Conditions:

A. Indoor installation is recommended. Dryers installed outdoors must be well

protected from precipitation, dust, dirt, debris and animals.

B. The unit should be installed in a well ventilated area. Ambient temperature must be

in the temperature range of 50°F to 110°F.

C. If the dryer must be installed in area containing airborne particles or fines, or in an

oily atmosphere conducive to the collection of dust and dirt particles on the surface of

and in-between the fins of the refrigerant condenser, install and maintain an ambient air

filter.

D. Position the dryer to allow free circulation of cooling air through the front and sides

of the dryer.

Mounting:

A. The dryer should be placed on a rigid, level surface.

B. If mounted on a shelf or on any surface or structure above the floor level, the dryer

should be bolted down using the mounting holes provided in the cabinet base. Not all

models have mounting holes.

C. The dryer should be isolated from excessive vibration, which could be transmitted

through the mounting surface or attachment piping.

Electrical:

A. For units 10 scfm through 100 scfm, the unit should be connected to an

appropriate grounded receptacle based upon its nominal voltage. Be sure the power

cord is protected from possible damage after installation. For units 150 scfm to 250

scfm, you may need a qualified electrician to aid in the connection with its terminal

block based upon its nominal voltage.

B. The dryer should be connected to a fused disconnect, having a fuse size not to

exceed the maximum fuse size indicated on the dryer data label.

C. Power supplied to the dryer must conform to the electrical specifications listed on

the dryer.

D. On models 150 scfm to 250 scfm, they have a junction box with a 1/2 inch knockout.

A conduit connector is provided. To connect to the terminals in the junction box,

remove the aluminum access plate. The access plate is held in place with two screws.

Thread the power cord through the conduit connector and, using the appropriate

electrical schematics in this literature, connect to the terminals in the junction box.

Replace the access plate.

Dryer installation should follow the installation arrangements shown in Figure 1. An

aftercooler and moisture separator with automatic drain are recommended to reduce the