- ページ 2

ドライヤー Bosch DryerのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Bosch Dryer 8 ページ。 Dryer
Bosch Dryer にも： 取付説明書 (6 ページ), 操作およびインストール手順 (8 ページ), 設置および取扱説明書 (28 ページ)

ページを印刷する
Bosch Dryer 取扱説明書
Installation
Technical data
– Delivery specification: dryer, instructions for installation and use, woollens basket
(depending on model).
– Check dryer for transport damage.
– The dryer is very heavy. Do not attempt to lift it on your own.
– Be careful to avoid sharp edges.
– Do not lift the dryer by any of the protruding parts (e.g. the door) as they may break off.
– Do not set up in a room that is susceptible to frost.
Freezing water may cause damage.
– If in doubt, have the appliance connected by an expert.
Setting up the dryer
1.
Take all accessory parts
– The appliance plug must always be accessible.
out of the drum.
The drum must be empty.
– Ensure that the appliance is installed on a clean, level
and solid surface.
– Keep the cooling grille at the front of the dryer
unobstructed.
Consumption rates
– Keep the area around the dryer clean.
– Make the dryer level using the threaded feet
and a spirit level.
Fabrics/programmes
Do not remove the threaded feet under any
circumstances.
Cottons 7 kg
Cupboard Dry*
Do not set up the dryer behind a door or sliding
door as this may obstruct or prevent the dryer door
from opening. This will prevent a potentially fatal
danger to children from locking themselves in.
Iron Dry*
Clean and level
Make sure that the air
inlet remains unobstructed
Easy-Care 3.5 kg
Cupboard Dry*
2.
Mains connection
see safety instructions
Page 11.
– Connect to an AC earthed socket. If in doubt have the socket checked by an expert.
– The mains voltage and the voltage shown on the rating plate (
Page 9) must correspond.
* Programme setting for testing in accordance with applicable standard EN61121.
– The connected load and necessary fuse protection are specified on the rating plate.
** The values may differ from those specified, depending on the type of fabric, composition of
laundry to be dried, residual moisture in the fabric and the amount of laundry being loaded.
Do not operate the dryer if
Fabrics/programmes
Frost protection / Transport
there is a danger of frost.
Cottons 7 kg / 3.5 kg*
Cupboard Dry***
Preparation
***Programme setting for testing and energy labelling in accordance with Directive 2010/30/EU.
1. Empty the condensation container
page 4.
2. Select any programme using the programme selector.
Optional accessories
3. Press the
Start/Stop button
condensation is pumped into the container.
4. Wait 5 min., and then empty the condensation container again.
WMZ
5. Turn the programme selector to Off.
20500
WTZ
11310
WTZ
1110
WTZ
10290
7
8
What to do if ...
Dimensions (DxWxH)
60 x 60 x 85 cm (height adjustable)
If you cannot rectify a fault yourself (e.g. switching off/on), please contact our after-sales
Weight
approximately 45 kg
service. We will always find an appropriate solution and will avoid unnecessary visits by
Max. capacity
7 kg
engineers. Trust the expertise of the manufacturer and rest assured that the repair will be
carried out by trained service technicians using original spare parts. The contact details of your
Condensation container
4.2 l
local after-sales service can be found in the enclosed after-sales service directory, or by
Connection voltage
calling one of these numbers:
Connected load
– GB 0844 8928979 (Calls from a BT landline will be charged at up to 3 pence per minute.
Fuse protection
see appliance rating plate
A call set-up fee of up to 6 pence may apply.)
Ambient temperature
– IE 01450 2655 (0.03 € per minute at peak. Off peak 0.0088 € per minute.)
Product number/
When contacting the after-sales service, please quote the appliance's product number (E no.)
and production number (FD) (see the inside of the door).
Production number
Set the programme selector to Off and remove the appliance plug from the socket.
You can find the rating plate on the back of the dryer.
The
Start/Stop indicator lamp
Drum interior light
(depending on model) (bulb E14, 25 W)
does not light up.
The drum lights up after the door is opened or closed, and after the programme starts,
and switches off automatically. Changing the bulb
page 10.
The display panel light and
indicator lights (depending on
model) go out and the
Stop indicator light flashes.
The Container and
Residual moisture in the fabrics
Energy
Drying time**
Start/Stop indicator lights are
after spinning
consumption**
flashing.
The Clean and
indicator lights are flashing.
1400 rpm
(50%)
106 min
3.60 kWh
Dryer does not start.
1000 rpm
(60%)
124 min
4.20 kWh
800 rpm
(70%)
143 min
4.80 kWh
1400 rpm
(50%)
82 min
2.59 kWh
1000 rpm
(60%)
98 min
3.28 kWh
Water is running out.
800 rpm
(70%)
112 min
3.96 kWh
The door opens by itself.
800 rpm
(40%)
42 min
1.35 kWh
Creasing.
600 rpm
(50%)
51 min
1.65 kWh
Drying result is not satisfactory
(laundry feels too damp).
Drying time
Annual energy consumption
97 min / per cycle
504 kWh / per year
Drying time too long.
(from after-sales service using order number)
Platform
For easier loading and unloading. The basket contained in the drawer can be used to carry
the laundry.
The humidity in the room
increases significantly.
Washer-dryer stack connection set
Mains failure.
The dryer can be placed on top of a suitable washing machine with the same width and depth
to save space. The dryer must be fastened to the washing machine using this connection set.
One or more indicator lights for
With pull-out worktop: WTZ 11300
programme status are flashing.
Connection fittings for condensation outlet
The condensation is conveyed directly via a hose.
The interior light is not working
Installation underneath the worktop
(depending on model).
Instead of the appliance covering plate, you must have a metal cover fitted by
a specialist.
9
Safety instructions
Emergency
– Pull the appliance plug out of the socket immediately or disconnect the fuse.
ONLY use the
– in rooms inside the house.
dryer...
– to dry fabrics.
The dryer must
– be used for other purposes than those described above.
NEVER...
– be modified in terms of its technology or attributes.
Dangers
– The dryer must not be used by children or persons who have not been
instructed in its use.
– Do not leave children unsupervised near the dryer.
– Keep pets away from the dryer.
– Remove all objects from pockets.
Make especially sure that cigarette lighters are removed as they constitute
Mains plug plugged in? Programme selected?
an
explosion hazard.
Check the socket fuse.
– Do not lean or sit on the door
Energy-saving mode is activated
Installation
– Secure loose cables
see the separate Energy-saving mode instructions.
– Do not operate the dryer if there is a risk of frost.
Start/
Mains
– Connect the dryer according to specifications to an AC earthed socket, as
connection
Empty the condensation container.
otherwise it cannot be guaranteed that the appliance is completely safe.
If featured, check hose for condensation outlet.
– The cable cross-section must be sufficient.
– Only use earth-leakage circuit breakers with the following symbol:
Start/Stop
Clean the fluff filter and/or air cooler under running water
– The appliance plug and socket must be compatible.
Page 4/6.
– Do not use multiple plugs/couplings and/or extension cables.
Start/Stop button selected?
– Do not hold the appliance plug with wet hands
Door closed?
– Never pull the appliance plug out of the socket by its cable.
Programme set?
– Do not damage the mains lead
Ambient temperature greater than 5 °C?
Operation
– Only load the drum with laundry.
Align dryer horizontally.
Clean air cooler seal.
Check the contents before you switch the dryer on.
Push the door closed until you hear it engage.
– Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
grease or paint (e.g. hair setting spray, nail polish remover, stain remover,
Laundry load exceeded?
cleaning solvent, etc.)
Remove articles of clothing immediately after
– Dust (e.g. coal dust, flour) poses a danger: do not use the dryer
the end of the programme, hang up and pull into shape.
explosion hazard.
Unsuitable programme selected
Page 7.
– Do not put laundry containing foamed material/rubber in the dryer
Warm laundry feels damper than it actually is.
material may be destroyed and the dryer may be damaged due to possible
The selected programme does not suit the load. Use another
deformation of the foamed material.
drying programme or, in addition, select the time programme
– Switch off the dryer once the programme has ended.
Page 7.
Use fine adjustment for the drying result
Page 5/6.
– Condensation is not drinking water and may be contaminated with fluff.
Fine layer of limescale on the humidity sensors
Defect
– Do not use the dryer if it is defective or if you suspect it is.
Clean the humidity sensors
Page 6.
Repairs must only be carried out by the after-sales service.
Programme termination, e.g. tank full, mains power supply failure,
– Do not use the dryer if the mains cable is defective. To avoid danger, only
door open or maximum drying time reached.
have the defective mains cable replaced by the after-sales service.
Rinse the fluff filters under running water
Page 4.
– Always pull the mains plug out of the socket before changing the bulb for the
Insufficient supply of air
ensure that air can circulate.
Air inlet possibly blocked
Clear inlet
Page 8.
interior light
Ambient temperature higher than 35 °C
ventilate the room.
Spare parts
– Only use genuine spare parts and accessories for safety reasons.
Make sure the room is sufficiently ventilated.
Disposal
– Dryer: pull out the appliance plug, then cut off the mains cable from
the appliance.
Remove laundry from the dryer immediately and spread out.
Dispose of at municipal waste disposal facility.
This allows the heat to dissipate.
– Packaging: do not leave children alone with packing parts
Clean filter and air cooler
Page 4/6.
risk of suffocation.
Check installation conditions
Page 8.
– All materials are environmentally sound and can be reused. Dispose of in
Switch off, leave to cool down, switch on again, restart
an environmentally-responsible manner.
programme.
Pull out the appliance plug, remove the cover cap in the interior
above the door (use Torx 20 screw driver) and replace
the bulb. Close the cover cap.
Never operate the dryer without a cover cap.
10
risk of tipping.
tripping hazard.
risk of electric shock.
risk of electric shock.
fire/explosion hazard.
elastic
Dryer
risk of electric shock.
en Instruction manual
11