- ページ 10

スピーカー Community MVP37のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Community MVP37 10 ページ。 Loudspeakers systems mvp series
Community MVP37 にも：仕様 (2 ページ)

USING MVP40 SUBWOOFER SYSTEMS

While all Community full-range speaker systems have remarkable

bass output, the MVP40 subwoofer has a lot more. A very special

feature of the MVP40 is that it has a built-in crossover with a high-

pass output. This means that you may use one channel of your

power amplifier to power both the MVP40 and a full-range speaker,

while presenting a reasonable load on your amplifier. The amplifier

only sees the subwoofer's crossover load, which is 8 ohms for the

MVP40 subwoofer. Without the built-in crossover, the

combined impedance of full-range and subwoofer speakers in

parallel would be much lower. Many amplifiers are capable of

powering very low-impedance loads, but some cannot. This feature

neatly solves that problem. Also, the high-pass crossover output

removes very low bass frequencies from the signal going to the full-

range speaker. This prevents excessive low-frequency energy getting

into the full-range speaker, causing possible damage.

STACKING OR INSTALLING LOUDSPEAKER ENCLOSURES

Common sense is a good guide. If you stack speakers, be sure they

are on a stable surface. If there is any danger of the speakers being

knocked over when stacked, don't stack them! You need to get the

speakers up high enough so that the sound doesn't "blow away" the

people nearest to the speakers, but piling speakers on top of a small

pedestal table is asking for trouble.

Several models of the MVP™ speakers have a socket for use with

tripod stands. Be sure to position them so that no one can trip over

the stand or knock over the loudspeaker.

Community MVP25, MVP35, MVP36 and MVP37 loudspeaker

enclosures are provided with 5/16"-18 thread "T-Nuts" (captive

threaded inserts) in the sides of the enclosures for hanging or

mounting. The accessory "STRAPKIT" provides three steel straps

that attach to these inserts for connecting rigging to the enclosure.

The smaller models may be mounted from walls or ceilings by using

the accessory WB-1.

WARNING: For your protection, under no circumstances should

any loudspeaker be mounted or suspended in a public place unless

the mounting method has been approved and certified by a

registered Professional Engineer. Do not suspend from handles.