- ページ 9

スピーカー Community R.35COAXのPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Community R.35COAX 13 ページ。 R series
Community R.35COAX にも：設置および操作マニュアル (17 ページ)

FIELD SERVICE

Any driver or crossover service required is accessed from the front of the enclosure by

first removing the front grille and then unscrewing and removing the LF driver or the

horn assembly. Take note of wiring positions prior to removing any drivers from the

loudspeaker. In order to maintain the weather resistance, components and assemblies

must not remain removed from the loudspeaker any longer than needed for replacement.

Exposure of internal components to the elements for extended periods could cause

failures and void the warranty on the loudspeaker.

__Remove the grille. Refer to illustrations in Figure 7. The grille frame locks into the

enclosure frame. Carefully insert a thin flat bladed screwdriver between the grille frame

and the enclosure frame while gently pressing down on the grille. Starting at the top and

moving down, twist the blade to pop the grille frame free of the enclosure. There is a

safety tether at the bottom of the grille that can be unhooked to fully remove the grille.

__Remove the screws holding the LF driver in the face and replace or service the

components as necessary.

__Replace the driver securing it with all of the original hardware.

Reattach the grille safety tether to the face and push the grille frame

into place - one side and then the other, ensuring that the frames are

fully seated. The grille should easily snap into place.

Insert thin blade of

screwdriver between frame

and enclosure and move

down seam while twisting to

pop grille loose

R.15COAX, R.35COAX, R.35-3896

Figure 7. Remove grille (R.15 shown)

Installation and Operation Manual

Unhook grille tether

to fully remove grille

Page 9