- ページ 28

ドライヤー Bosch Series 4のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Bosch Series 4 44 ページ。 Free standing cooker
Bosch Series 4 にも：取扱説明書 (24 ページ), 取付・使用説明書 (16 ページ), 取付・使用説明書 (16 ページ), 取扱説明書 (16 ページ), 取扱説明書 (24 ページ), 取扱説明書 (10 ページ), 取扱説明書 (12 ページ), 取扱説明書 (20 ページ), 取扱説明書 (32 ページ), 取付説明書 (12 ページ), マニュアル (2 ページ), クイック・リファレンス・マニュアル (2 ページ), ユーザーマニュアル (16 ページ), 取扱説明書 (50 ページ), ご利用案内 (24 ページ), 取扱説明書 (48 ページ), ご利用案内 (32 ページ), ご利用案内 (32 ページ), ユーザーマニュアル (32 ページ), ご利用案内 (32 ページ), 取扱説明書 (24 ページ), 取扱説明書 (27 ページ), ユーザーマニュアルと設置手順 (40 ページ), ご利用案内 (32 ページ), 取扱説明書 (36 ページ), ユーザーマニュアル (24 ページ), 取扱説明書 (47 ページ), ユーザーマニュアルと設置手順 (28 ページ)

ページを印刷する

Trouble shooting

Lift the panel up and pull it out (fig. C).

Clean the panels with glass cleaner and a soft cloth.

Warning – Risk of injury!

Scratched glass in the appliance door may develop into

a crack. Do not use a glass scraper, sharp or abrasive

cleaning aids or detergents.

Installation

During installation, make sure that the lettering "top

right" is upside down at the bottom left.

Insert the panel at an angle towards the back

(fig. A).

Insert the top panel at an angle towards the back

into the brackets. The smooth surface must face

outwards. (fig. B).

Put the cover back in

place and press on it.

Attach the oven door.

Do not use the oven again until the panels have been

correctly installed.

3Trouble shooting

I f a fault occurs, there is often a simple explanation.

T r o u b l e s h o o t i n g

Before calling the after-sales service, please refer to the

fault table and attempt to correct the fault yourself.

Rectifying faults yourself

You can often easily rectify technical faults with the

appliance yourself.

If a dish does not turn out exactly as you wanted, you

can find useful cooking tips and instructions at the end

of this instruction manual. ~ "Tested for you in our

cooking studio" on page 30

Fault

Possible

cause

The appliance is

Defective cir-

not working.

cuit breaker.

Power failure Check whether the kitchen light

The time is flash-

Power failure. Reset the time.

ing on the display.

The settings on

The child-

the appliance

proof lock is

cannot be config-

activated.

ured. A key sym-

bol has lit up on

the display or

†'""

Cleaning rec-

'–

appears on

ommenda-

the display.

tion.

The gas burner

Power cut or

does not ignite.

damp ignition

plugs.

--------

Warning – Risk of electric shock!

Incorrect repairs are dangerous. Repairs may only be

carried out and damaged power cables replaced by

one of our trained after-sales technicians. If the

appliance is defective, unplug the appliance from the

mains or switch off the circuit breaker in the fuse box.

Contact the after-sales service.

Error messages on the display

If an error message with "

e.g.

, touch the

"‹†

„ƒ

error message. Reset the time, if necessary.

If the fault was a one-off, you can continue to use your

appliance as normal. If the error message appears

again, call our after-sales service and quote the exact

error message and the E no. of your appliance.

~ "Customer service" on page 29

Notes/remedy

Check the circuit breaker in the

fuse box.

or other kitchen appliances are

working.

Deactivate the childproof lock by

pressing and holding the button

with the key symbol for approx. 4

seconds.

Run the cleaning function in full.

The message can be dismissed

by pressing any button. It will con-

tinue to be displayed, however,

until the cleaning function has

been run in full.

Light the gas burner with a gas

lighter or a match.

" appears on the display,

button. This will reset the