- ページ 8

ソウ ATIKA BTU 450のPDF 取扱説明書、安全上のご注意、スペアパーツをオンラインで閲覧またはダウンロードできます。ATIKA BTU 450 11 ページ。 Construction circular saw

3. Insert rod (33) into motor-shaft and unscrew bolt (

4. Now, the front saw blade flange (27) and the saw blade (26) can be

removed.

Clean the saw blade flanges.

6. Install a new or sharpened saw blade.

Pay attention to the correct running direction of the saw blade: The

arrow on the saw blade and the arrow on the protective cover must point

in the same direction!

7. Position the front saw blade flange again.

8. Re-tighten the clamping nut (28).

9. Secure the table insert.

10. Fold the safety guard back to its original position.

Replacing the table insert

Disconnect the mains plug before changing the table

insert.

Immediately replace a worn or damaged table insert.

1. Fold back the safety guard (15).

2. Loosen the screws of the table insert (6) and move it back.

3. Remove the 2 nuts (a) and remove the blade guard (12) together with the

safety guard.

4. Install a new table insert (6).

5. Secure the blade guard with the safety guard (for blade guard adjustment

see figure 13).

6. Secure the table insert.

7. Fold the safety guard back to its original position.

Blade guard adjustments

The adjustment of the blade guard must be checked after each saw blade

and table insert change.

left-hand-thread)

Please observe the enclosed terms of guarantee.

Before each transport:

− Switch off device

− Wait unitl the saw comes to a stop.

− Pull out power plug

− Accessories such as stops must be securely

mounted or clamped on the machine.

Pull out power plug

Store unused equipment in a dry, locked place out of the reach of children.

Before a longer period of storage carry out the following to extend the saw

service life and ensure an easy operating:

− thoroughly clean the device

− treat all movable parts with an environmentally friendly oil

Never use any grease!