ケーブルとコネクター Anderson POWER EBC E80のPDF 組み立て説明書をオンラインで閲覧またはダウンロードできます。Anderson POWER EBC E80 4 ページ。 Female connector
ページを印刷するBase Kit Components:
FEMALE HOUSING
Optional Kit Components:
FEMALE SOCKETS
1.
Strip wire per length specified in the table below (Figure 1)
Contact Type
Power
Upper/Lower Pilot/Auxiliary
2.
Insert wire into contact crimp barrel until wire bottoms in barrel. Solder or crimp contacts. Note: If using a double crimp locator, as shown in Figure 1A
make the outer crimp first, then the inner crimp.
3.
Pick up the holder and locate the Top and Bottom sides based on the diagrams below.
Polarity Markings
Front
Clips for Upper
Auxiliary Contacts
TOP VIEW CONTACT HOLDER
4. For Use of Air Tube (Installed on bottom side):
a. Orient air tube (Figure 2) so that air inlet faces towards holder
b. Line up air tube circular grooves in air tube to U-shapes in holder
c. Press on air tube until the grooves snap into the U-shapes
d. Air tube should stay in place when holder is flipped over
5. For Use of Lower Pilot/Auxiliaries (Installed on bottom side):
a. Orient lower pilot/auxiliaries as shown in (Figure 3)
b. Line up contact grooves to U-shapes in holder
c. Press on each contact until the groove snaps into the U-shape
Page 1 All Data Subject to Change Without Notice
© 2023 Anderson Power Products, Inc. All rights reserved. Anderson Power Products®, A® and the Anderson Power™ logo are registered trademarks of Anderson Power Products, Inc.
HEADQUARTERS: Anderson Power Products®, 13 Pratts Junction Road, Sterling, MA 01564-2305 USA T: +1 978-422-3800 F: +1 978-422-0128
Your Best Connection
EBC E80 Female Connector Assembly Instructions
CONTACT HOLDER
LOWER PILOT/AUX. SOCKETS
UPPER AUX. SOCKETS
NOTE: Use either air tube or lower pilot/auxiliary contacts
Wire Size
2
10 – 35mm
2
1.5 -2.5 mm
Locking Tab
™
GREY OR GREEN
VOLTAGE PIN
CABLE CLAMPS
CONTACT HOLDER
FEMALE AIR TUBE
Dim. A
20mm
8mm
Figure 1
U-shapes for
Lower Pilot/
Auxiliaries or Air
Front
tube
Front
ECN 2023-0043
Tools Required:
Crimp or solder tool*
#2 Phillips head screw driver
Torque wrench
Small Flat screwdriver
*Aux Contacts are solder only
Crimp Barrel
2ND 1ST
Figure 1A
BOTTOM VIEW CONTACT HOLDER
Air Inlet Faces
Down
Figure 2
Figure 3
Spec. No. 1S6676, Rev. 3
HANDLE