- ページ 6

スピーカー Andersson PLS 2.1のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Andersson PLS 2.1 19 ページ。 Powerful bluetooth speaker

ページを印刷する

Instructions

Input

Input mode is initially set to USB/SD when powered on.

Press INPUT to change the input/playback mode. The input

order is Bluetooth, USB, SD, AUDIO IN

Bluetooth and Pairing

Press the Input button to switch to Bluetooth input. The

Bluetooth indicator LED will start blinking, to indicate that

the Bluetooth speaker has entered pairing mode. Make

sure that Bluetooth is activated on the transmitting blue-

tooth device (such as smartphone, tablet or computer),

then go into the bluetooth settings of the transmitting blue-

tooth device and search for PLS 2.1 and connect with the

input pass code '0000'. The Bluetooth speaker will make

a sound once the devices have been successfully paired.

The LED will stop blinking and will instead be statically lit.

´ If PLS 2.1 cannot be found, try to turn Bluetooth off and

on again on the Bluetooth device. Switch the Bluetooth

speaker input mode from Bluetooth to AUX and back

again by pressing the input button. Try pairing again.

´ If the Bluetooth signal is weak, the Bluetooth speaker

will automatically attempt to re-connect with your de-

vice. Otherwise follow above steps to pair again man-

ually.

´ The Bluetooth speaker will automatically connect with

the paired device. If you want to pair with another de-

vice, turn off Bluetooth or disconnect from the paired

device.

Battery Charge/Low Battery LED

When the battery is fully recharged, the LED will turn off.

When charging, the LED will be lit in RED. When the battery

is low, the LED will be blink in RED.

Power/Standby Indicator LED

Once the Bluetooth speaker is turned on, the LED will be lit

in GREEN. The LED changes to red colour once the speak-

er enters standby mode. The speaker goes into standby

mode after a few minutes of no signal or activity in order to

save power.

AUX (AUDIO IN/USB/SD Input) Indicator LED

The LED will be lit when the input mode is AUDIO IN, USB

or SD.

Bluetooth Indicator LED

When the Bluetooth speaker is set to Bluetooth input, the

LED will be lit.

Backward, Play/Pause, Forward

These buttons are used to control music playback when the

input mode is USB, SD or Bluetooth. These buttons can not

control AUDIO IN.