- ページ 23

ドライヤー Bosch WTW87569SNのPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。Bosch WTW87569SN 32 ページ。

ページを印刷する

Faults and what to do about them

F a u l t s a n d w h a t t o d o a b o u t t h e m

Faults

ð on the display panel

and drying has been

interrupted.

é on the display panel. Clean the fluff filter and press the Start button ~ Page 17.

SelfCleaning on the '

display panel.

Dryer does not start.

Creasing.

Water is leaking out.

Laundry is not dried cor-

rectly or is still too damp.

* depending on the model

Cause/remedy

Empty the condensate container and press the Start button ~ Page 19.

■

If the optional condensation drain* is installed, the drain hose may be

■

blocked or kinked. Check the hose for deposits and flush the hose out. Lay

the hose without any kinks.

Not a fault. The heat exchanger is cleaned automatically. Do not pull out the

condensate container while this is displayed.

Mains plug plugged in or fuse checked?

■

Programme selected? Select a programme.

■

Dryer door open? Close the door.

■

Childproof lock activated? Deactivate the childproof lock.

■

"Ready in" time selected? Programme starts after a delay ~ Page 15.

■

Creasing occurs when you have exceeded the maximum load or selected

■

the wrong programme for the type of fabric. All the required information

can be found in the programme table ~ Page 13.

Remove clothes immediately after drying; creasing may occur if they are

■

left in the drum.

Not a fault; the dryer may be positioned on an incline. Level the dryer.

After the end of the programme, warm laundry feels damper than it actually

■

is. Spread the laundry out and allow the heat to disperse.

Finely adjust the dryness level – this extends the drying time but does not

■

increase the temperature. Your laundry will become drier ~ Page 15.

Select a programme with a longer drying time or increase the drying level.

■

This does not increase the temperature.

Select a timed programme for subsequent drying of laundry that is still

■

damp ~ Page 13.

If you have exceeded the maximum load for the programme, the laundry

■

may not be dried properly.

Clean the moisture sensor in the drum. A fine layer of limescale may

■

adversely affect the performance of the sensors and your washing will not

dry properly ~ Page 22.

Drying has been interrupted as a result of a power cut, because the conden-

■

sate container is full or because the maximum drying time has been

exceeded.

Note: