- ページ 38

ドライヤー Bosch WTY87879SNのPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。Bosch WTY87879SN 44 ページ。

ページを印刷する

Faults and what to do about them

Faults

Laundry is not dried cor-

rectly or is still too damp.

Drying time too long?

Display panel goes off

and Start button flashes.

Residual water in

the condensate con-

tainer despite the dryer

being connected to

the condensation drain*.

Humidity in the room

increases.

Power cut.

Unusual noises when

drying.

The dryer feels cold

despite drying.

* Depending on the model

If you cannot rectify the fault yourself by turning the dryer off and on, please

Note:

contact our after-sales service.

Cause/remedy

After the end of the programme, warm laundry feels damper than it actually

■

is. Spread the laundry out and allow the heat to disperse.

Finely adjust the dryness level – this extends the drying time but does not

■

increase the temperature. Your laundry will become drier ~ Page 29.

Select a programme with a longer drying time or increase the drying level.

■

This does not increase the temperature.

Select a timed programme for subsequent drying of laundry that is still

■

damp ~ Page 27.

If you have exceeded the maximum load for the programme, the laundry

■

may not be dried properly.

Clean the moisture sensor in the drum. The sensor may become covered by

■

a fine layer of limescale or residues of detergents and care products which

then impair its function. Your laundry is not being dried correctly

~ Page 35.

Drying has been interrupted as a result of a power cut, because the conden-

■

sate container is full or because the maximum drying time has been

exceeded.

Note: