- ページ 5

ネットワーク・ルーター Comnet NetWave NWK7E/MのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Comnet NetWave NWK7E/M 9 ページ。 Mini industrial outdoor high throughput 802.11a/n wireless ethernet kit

ページを印刷する

QUICK START USER GUIDE

INSTALLATION REQUIREMENTS

Shielded outdoor CAT 5 or better should be used for all out of plant Ethernet connection and should be properly grounded

through the PoE AC ground. Industrial grade shielded Ethernet cable is recommended to help prevent ESD damage commonly

experienced with outdoor installations. Visit www.comnet.net/comnet-products/cables

CONFIGURING NETWAVE

1. Connect an Ethernet cable from the port labelled as IN on the power Injection Module to either a laptop or a PC LAN port.

2. Connect the second Ethernet cable from the OUT port on the Power Injection Module to the NetWave LAN port.

3. Apply 48 VDC to the Power Injection Module with the provided power supply. You should notice the green LED illuminate in

the Power Injection Module and the power LED on the NetWave unit.

4. Set the IP address of the laptop being used to configure NetWave to static and the subnet to 192.168.10.x/24 subnet.

5. Point the Browser to 192.168.10.100 for the Access Point or 192.168.10.101 for the Client. These are the default addresses.

6. A login prompt will pop up. Enter:

ID: admin

Password: admin

7. Select the NETWORK » Interfaces tab, click on Edit in the LAN settings section to change the IP address of the device. and set

the desired network settings.

• Hit Save & Apply

NOTE: This will be the network address for the NetWave web server. It is not necessary to set to the same subnet as the

operating network but it is recommended.

8. Select the NETWORK -> WIFI tab and set:

• Wireless mode – Set to AP or Client

• Country code – Only required if setting up the NW7E/M and NWK7E/M (ETSI) models

NOTE: It is the user's responsibility to ensure that the correct country is chosen. ComNet accepts no liability for incorrectly set

up equipment.

• Output RF power – if RSSI is greater than -40, it is recommended to reduce RF TX power at the connected remote node.

• Set SSID – if changing from the default setting

• Channel Spectrum Width – May want to reduce to 20M from the default 20/40M if the 5GHz spectrum is crowded or

connections across the link are unstable.

• Wireless Security – if changing from default settings

• Hit Save & Apply

DEFAULT CONFIGURATIONS

IP Address of Web Server

LAN Mode for Web Server

Web Server User ID

Web Server Password

SSID

WPA Pre-shared Key

Channel-Frequency (AP)

Channel Spectrum Width

Long Range Parameters

NOTE: A Reset to defaults (performed on the ADMIN page or via the RESET button) will erase all user configurations.

TECH SUPPORT: 1.888.678.9427

192.168.10.100 (NWKX/M_AP)

192.168.10.101 for all others

Static Addressing

admin

NetWave-1

12345678

Auto

20/40M

Enabled and defaulted to 1000m

NWK7[E]/M

INS_NWK7M_NWK7EM_QS_REV– 07/7/15 PAGE 5