- ページ 8

メディア・コンバーター Comnet FVT1D1S1のPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Comnet FVT1D1S1 8 ページ。 Digitally encoded video with bi-directional data and simplex contact closure

Comnet FVT1D1S1 設置および操作マニュアル
MECHANICAL INSTALLATION INSTRUCTIONS

INSTALLATION CONSIDERATIONS

The ComFit fiber optic links in this series are supplied as a Standalone/
Rack module. The FVT1D1/M is supplies as a Standalone/Surface-mount
module. Units should be installed in dry locations protected from
extremes of temperature and humidity.
C1-US, C1-EU, C1-AU OR C1-CH CARD CAGE RACKS
CAUTION: Although the units are hot-swappable and may be installed
without turning power off to the rack, ComNet recommends that the
power supply be turned off and that the rack power supply is disconnected
from any power source. Note: Remove electrical connector before
installing in card cage rack.
1. Make sure that the card is oriented right side up, and slide it into the
card guides in the rack until the edge connector at the back of the card
seats in the corresponding slot in the rack's connector panel. Seating
may require thumb pressure on the top and bottom of the card's front
panel.
CAUTION: Take care not to press on any of the LEDs.
2. Tighten the two thumb screws on the card until the front panel of the
card is seated against the front of the rack.
WARNING: Unit is to be used with a listed Class 2 power supply.
IMPORTANT SAFEGUARDS:
A) Elevated Operating Ambient - If installed in a closed or multi-unit rack
assembly, the operating ambient temperature of the rack environment may
be greater than room ambient. Therefore, consideration should be given to
installing the equipment in an environment compatible with the maximum
ambient temperature (Tma) specified by the manufacturer.
B) Reduced Air Flow - Installation of the equipment in a rack should be such
that the amount of air flow required for safe operation of the equipment is not
compromised.
© 2013 Communications Networks Corporation. All Rights Reserved. "ComNet" and the "ComNet Logo" are registered trademarks of Communication Networks, LLC.
FIGURE A
Dimensions are for a standard ComNet one slot module
FIGURE B
Dimensions are for a ComNet
3 CORPORATE DRIVE | DANBURY, CT 06810 | USA
T: 203.796.5300 | F: 203.796.5303 | TECH SUPPORT: 1.888.678.9427 | [email protected]
8 TURNBERRY PARK ROAD | GILDERSOME | MORLEY | LEEDS, UK LS27 7LE
T: +44 (0)113 307 6400 | F: +44 (0)113 253 7462 | [email protected]
.156 [3.96 mm]
.313 [7.95 mm]
small size module
INS_FVT/FVR1D1(M,S)1[M]_FVR2D2(M,S)2_REV– 04/05/12 PAGE 8