- ページ 4

メディア・コンバーター Comnet RLMCSFPPOEHOのPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Comnet RLMCSFPPOEHO 6 ページ。 Electrical substation-rated 10/100/1000 mbps ethernet media converter with optional high-output power over ethernet

ページを印刷する

INSTALLATION AND OPERATION MANUAL

Installation Instructions

Figure 4 – DIP Switches

DIP Switches on RLMCSFP24DC,

RLMCSFP48DC, and RLMCSFPPOEHO

Models

Table 2 – DIP Switch Settings

SW NAME

Link Fault Enable Port 1 Link Fault Pass-Through Disabled

–

FFE

PS Fault Enable

–

1000/100 (SFP Speed)

1 - SET DATA RATE DIP SWITCHES

Locate the 100/1000 data rate DIP switch on the bottom panel of the unit.

Set the data rate according to bandwidth required.

NOTE: If two units are connected via the SFP Port, the data rate must be set the same on both units, and must match the

data rate of the installed SFPs. Data rate settings are read on start-up, so restart the unit after making any changes.

2 - SET FAULT DIP SWITCHES

Locate the LFE, FFE, and PSE DIP switches on the bottom panel of the unit.

LFE1: If the Copper Port is Down or Not Connected, the Optical Port will turn on and off at a ~1 sec rate to indicate copper port

fault and the alarm relay will be triggered.

FFE: If the optical link is lost or there is a power failure then the alarm relay output will be triggered.

NOTE: You may select multiple fault event triggers.

NOTE: Power Supply Fault DIP Switch is only available on Redundant Power Models. When a redundant power supply is

available, a failure of power on one power supply will trigger the alarm relay output.

NOTE: Restart not required when making changes to this DIP switch setting.

3 - CONNECT GROUND WIRING

Connect Ground Wiring to ground screw and tighten nut to secure.

4 - CONNECT FAULT RELAY WIRING

Connect Fauly Relay device to 3-pin terminal block. The COM to N/C will be shorted in the fault condition.

5 - CONNECT DATA WIRING

Connect RJ-45 Ports to field wiring using Cat5/5e/6 cable.

6 - CONNECT NETWORK WIRING

Using fiber optic cabling appropriate to the installed SFP, connect the unit to a network device.

TECH SUPPORT: 1.888.678.9427

DIP Switches on RLMCSFPHV Model

OFF (DOWN)

N/A

Fiber Fault Relay Disabled

Power Supply Fault Relay Disabled

N/A

100 Mbps Speed Set Speed must match speed of installed

SFP. Reset power if switch or SFP is changed.

(UTP MODELS ONLY, FOR COAX MODELS SKIP TO STEP 3)

ON (UP)

Link Fault Pass-Through Enabled

N/A

Fiber Fault Relay Enabled

Power Supply Fault Relay Enabled

N/A

1000 Mbps Speed Set. Speed must match speed of

installed SFP. Reset power if switch or SFP is changed.

RLMCSFP SERIES

INS_RLMCSFP_REV–

Rev. 18 Sep 2020 PAGE 4