- ページ 3

トランシーバー Comnet FDX55S2のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Comnet FDX55S2 12 ページ。 Rs-232/422 drop and repeat data transceiver

INSTALLATION INSTRUCTIONS

1) ANTI-STREAMING SELECT SWITCH

The anti-streaming function is provided to protect the communications channel in the

event that a controller should go into a streaming or data-storming condition.

If the anti-streaming is to be used, it must be set to a setting that will exceed the longest

possible data transmission time that will exist on that channel. It should be noted that in

most installations, the anti-streaming will not be utilized and the switch should be left in the

factory default "Off" position. See Pg. 11, Fig.18.

2) DTE/DCE SELECT SWITCH

The purpose of this switch is to transpose the RS-232 data transmit and data receive signals.

Normally, this switch will be left in the factory default "DCE" position.

See Pg. 9, Fig.12 through Fig. 15.

3) LINKING PORT, J3

J3 is an RJ-11 connector utilized for electrically connecting two co-located FDX55 units.

For example, at some point on an east-to-west communications channel, it may be desired to

extend the channel in the north-to-south direction. A second FDX55 may be added in the same

cabinet as another existing FDX55, and the second unit would be utilized for extending the

channel in the north-to-south direction. A conventional straight-through interconnect cable

terminated at each end with RJ-11 connectors is required when connecting the two FDX55

units. It is desirable to keep the length of this cable as short as possible, so as to minimize

any possibility of stray electrical pick-up corrupting the quality of the data, which could

result in data errors. See Pg. 8, Fig. 11 and Pg. 10, Fig. 17.

4) A/B SELECT SWITCH

The purpose of this switch is to transpose the data transmit and data receive signals when

connecting two co-located FDX55 units utilizing the J3 expansion port and a straight-through

data interconnect cable. One FDX55 will be set to "A" and the second FDX55 will be set to "B" . If a

cross over cable is used, then both FDX55s would be set to "A" . This interconnect cable should be

kept as short as possible to eliminate EMI/RFI noise injection. Refer to Figure 1 for

typical configuration. Factory default for this switch is "A" . See Pg. 1, Fig.1.

Power Sources - The product should only be operated from the recommended power source.

Use only a UL Class 2 indoor/dry or Class 3 outdoor/wet power supply.

WARNING: Unit is to be used with a Listed Class 2 or LPS power supply rated 9-12 VDC @ 1A.

WARNING: This unit should be installed in a restricted access location; available through the use

of a lock and key or other means of security. Access should be limited to service personnel who

have been instructed about the reasons for the restrictions to the location. Any and all

precautions should be taken and controlled by the authority responsible for the location.

FDX55 SERIES

RS-232/422 DROP AND REPEAT

DATA TRANSCEIVER

INS_FDX55_REVB

01/22/09

Page 2