- ページ 2
コントロールユニット Atkinson Electronics GSCM-MINI-DのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Atkinson Electronics GSCM-MINI-D 16 ページ。 Generator start control module
Atkinson Electronics GSCM-MINI-D にも： クイックマニュアル (9 ページ)
ページを印刷する
Table of Contents
Modes of Relay Operations
...................................................
Typical Wiring Diagram
........ ...........................................
.............................................................
Option 2 Diagram
.............................................................
Option 3 Diagram
.............................................................
Option 1 Starting Sequence
..................................................................
.........................................................
Not Included.......
Outback 48 Volt inverter
systems require isolation relay
A0365
www.atkinsonelectronics.com
800.261.3602
............................................
..............................................
............................................
............................................
............................................
...................................
.............................................
....................
.................................
.....................................
....................
......
.............
...........
Features & Applications
Inexpensive 2 wire to 3 or 4 wire start controller
for electric start 3 or 4 wire diesel generators
3
Optimized for use with Outback Invertors
3
Supports three types of 3 or 4 wire generator
3
control: Momentary, Maintained & Ignition
4
Fixed crank time, over and under Hz
shutdown, and optional battery charging
5
thresholds
5
Maximum auto-start run time limit (6 hours)
5
Remote run and fault indication included
6
ABS epoxy sealed for harsh environment operation
7
Solving your generators 2 to
8
9
3 or 4 wire start-stop problem.
9
10
Description
10
The GSCM-mini-d is a micro-processor based generator
11
start-stop module, designed to auto start-stop diesel
11
generators that need a 3 or 4 wire connection from a 2
wire 12 volt or dry contact manual start command. The
12
GSCM-mini-d automatically disconnects the starter
13
when it either receives a remote start indication lamp
14
signal (connected to terminal 8) or an AC Hz signal from
15
the generator (AC connected to terminals 9 & 10).
16
Various LEDs are blinked or turned on to indicated the
run or fault status of the GSCM-mini-d. Manually
resetting the GSCM-mini-d by removing the power and
removes any lockout that allows the generator to
restart if called to do so.
The GSCM-mini-d is powered by 12VDC from the
generator battery and can monitor the battery voltage
and start the generator to charge its own battery if
connected to pin 4. The GSCM-mini-d is a limited
function controller that is part of the GSCM family.
All auto start battery voltage thresholds are
fixed, if adjustability is required use the GSCM
full function Generator Start Control Module.
2
Circuit Board Division
Revised 11/2020