- ページ 13

ホブ Electrolux EGT7353NOKのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Electrolux EGT7353NOK 20 ページ。 70cm wide gas on glass with 5 burners and individual cast iron supports.
Electrolux EGT7353NOK にも：ユーザーマニュアル (16 ページ), ユーザーマニュアル (20 ページ)

ページを印刷する

1. Installation

With a thin screwdriver, adjust the by-

pass screw position.

The by-pass screw

• If you change from natural gas G20 20

mbar to liquid gas, fully tighten the by-

pass screw in.

• If you change from liquid gas to natural

gas G20 20 mbar, undo the by-pass

screw approximately 1/4 of a turn (1/2

of a turn for Triple Crown burner).

WARNING!

Make sure the flame does not go

out when you quickly turn the

knob from the maximum position

to the minimum position.

8.5 Electrical connection

• Do not pull the mains cable to discon-

nect the appliance. Always pull the

mains plug.

• The appliance must not be connected

with an extension cable, an adapter or

a multiple socket. There is a risk of fire.

• Do not let the power cable to heat up

to a temperature of more than 90° C.

The cable should be guided by means

of clamps fixed to the side of the cabi-

net, in order to avoid any contact with

the equipment beneath the cooktop.

• Make sure that there is access to the

mains plug after the installation.

Electrical Requirements

Permanent electrical installation must

agree with the latest I.E.E. Regulations

and local Electricity Board regulations. For

your own safety the installation must be

done by a qualified electrician (e.g. your

local Electricity Board, or a contractor

who is on the roll of the National Inspec-

tion Council for Electrical Installation Con-

tracting [NICEIC]).

The manufacturer refuses to

be held responsible, if these

safety measures are not abi-

ded by.

Supply connections:

This hob has to be connected to 230 —

240 V ( 50 Hz) electricity supply.

The hob has a terminal block which is

marked as follows:

• L — Live terminal

• N — Neutral terminal

•

or E — Earth terminal

Before carrying out the connection, make

sure:

The limiter valve and the electrical

system can take the appliance load

(see the rating plate)

The supply system is equipped with

an efficient earth connection in com-

pliance with the current standards

and regulations

The outlet or omnipolar switch used

for connection is easily accessible

with the appliance installed.

The appliance is supplied with a 3 core

flexible powercable with a 3 amp plug. If it

is necessary to change the fuse, use a 3

amp ASTA-approved (BS 1362) fuse.

Green and Yellow

3 amp fuse

Brown

Cord clamp

Blue

The wires in the cord are coloured as fol-

lows:

Green and yellow

ENGLISH

- Earth