- ページ 7

フロアマシン comoc CM1500 VのPDF マニュアルの使用とメンテナンスをオンラインで閲覧またはダウンロードできます。comoc CM1500 V 14 ページ。

INSTALLING THE HANDLEBAR

Insert the handlebar in its vertical position, placing the support in the

four holes on the base. Insert the four M8 screws.

Tighten the screws one at a time, holding the self-locking nuts below

the base in their seats.

Connect the gas spring to the support by pressing it in by hand.

Connect the power cable to the motor.

WARNING!

disconnected from power mains and wear suitable

protective gloves before you proceed to install the

pad.

Use the handlebar to slope the machine back until it rests on the floor

(handlebar horizontal, machine vertical). Remove the clip from the

motor hub and screw on the drive disk. Mount the pad on the disk,

supporting it with one hand and tightening fastening ring (2) with the

other (turning it clockwise), using the special handle (1) provided with

Use the handlebar to bring the machine back up into its vertical

position.

The machine must be perfectly horizontal and positioned on the

vertical of the disk.

Connect the power plug into the power mains. Move the handlebar

horizontally until you achieve proper rotation stability. Then release

the levers to turn the machine off.

PREPARING THE MACHINE

Check

that

the

power

plug