- ページ 15

ホブ Electrolux EHDP9730IKのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Electrolux EHDP9730IK 20 ページ。
Electrolux EHDP9730IK にも: 取扱説明書 (20 ページ)

Electrolux EHDP9730IK マニュアル
comes on.
comes on.
If you tried the above solutions and can-
not repair the problem, speak to your
dealer or the customer service. Give the
data from the rating plate, three digit letter
code for the glass ceramic (it is in the cor-
ner of the glass surface) and an error
message that comes on.

8. INSTALLATION

WARNING!
Refer to the Safety chapters.
Before the installation
Before the installation of the appliance, re-
cord the information below from the rating
plate. The rating plate is on the bottom of
the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................
8.1 Built-in appliances
• Only use the built-in appliances after
you assemble the appliance into correct
built-in units and work surfaces that
align to the standards.
8.2 Connection cable
• Use the correct mains cable of type
H05BB-F Tmax 90°C (or higher) for a
single phase or two phase connection.
Problem
Possible cause
The cooling fan is
blocked.
The electrical connection
is incorrect. The appli-
ance is connected only to
one phase.
Make sure, you operated the appliance
correctly. If not the servicing by a custom-
er service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the cus-
tomer service and conditions of guarantee
are in the guarantee booklet.
• Replace the damaged mains cable with
a special cable (type H05BB-F Tmax
90°C or higher). Speak to your local
Service Centre.
8.3 To attach the seal.
• Clean the worktop in the area of the cut
out section.
• Bond the seal stripe supplied on the
lower edge of the appliance along the
outer edge of the glass ceramic. Do not
extend it. Let stay the cut ends in the
middle of one side. When, you cut it to
length (add some mm), push the two
ends together.
ENGLISH
Remedy
Check if objects block the
cooling fan. If
comes
on again, speak to the
service center.
Connect the appliance as
you see it in the connec-
tion illustration.
15