- ページ 12

水ポンプ Compac L160SDのPDF インストールとセットアップの説明をオンラインで閲覧またはダウンロードできます。Compac L160SD 16 ページ。

Standalone Operation

12.

In standalone operation, the dispenser will continue working when not connected to a controller.

'Stand-alone' mode being when no authorisation of fills is required and so fills are simply

initiated by removing the refuelling assembly from its holder. If standalone operation is inhibited,

the dispenser will not work in 'stand-alone' mode, regardless of whether the dispenser is ON

LINE to a controller or not.

The dispenser ceases to work in 'stand-alone' mode if connected to a controller, regardless of

the position of standalone setting.

Generally on retail forecourts the dispenser should be set-up for standalone operation. Hence, if

the forecourt controller breaks down the dispensers can be set to work in 'stand-alone' mode

simply by turning them off then on again.

For unattended refuelling sites, the dispensers should not be able to work in 'stand-alone' mode

in the event of a controller failure. Therefore the dispenser should be set-up to inhibit

standalone operation.

This is set in the 'b' code on the K factor switch.

The 'b' code to run Standalone without Dispenser Controller is '0000'.

The 'b' code to inhibit Standalone is '1000'.

13.

In the event of a fuse blowing on the C4000 Power supply a bag of 3 is included in each

flameproof box. Any fuses used from this bag should be replaced

Note: There are three different ratings used. If replacing a fuse, ensure that the correct value is

used.

14.

The power output from onsite generators can cause power spikes that may damage electrical

components within the cabinet. When connecting to sites powered by generators, please take

the following precautions:

1) Install a power conditioner. Although generators are fitted with power regulators, most are

not filtered sufficiently for powering sensitive electrical components. We recommend

installing a commercial power conditioner and/or UPS between the generator and the unit.

2) Starting up. Before starting a generator, make sure the power to the unit is turned off.

Start the generator, let the generator reach stable operating speed and wait 30 seconds

before reconnecting the power to the unit.

3) For units where the generator starts and stops on demand, install a delay timer or PLC to

automatically isolate the unit until the operating speed and consistent power output is

achieved.

4) Isolate the unit before shutting down the generator.

\\Cilaklfs1\shrdata\Masters\Installation Sheets\Laser\L160SD Installation Sheet.doc

Page 12 of 16