- ページ 5

アウトドアカート Compac WD60 G2のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Compac WD60 G2 14 ページ。 Wheel dolly

Installation of wheels:

Roll the wheel up over the wheel dolly's leg and up in the two supporting rolls, with the tyre

against the lifting beam (Fig. 13).

Move the wheel dolly with the wheel towards the vehicle.

Pump with foot pedal (A) (Fig. 12) until the wheel is in the desired height.

Move the wheel into place and secure the wheel with the wheel bolts.

Lower lifting beam with handle (E) (Fig. 16) and move the wheel dolly away from the vehicle.

Transport with wheel:

Ensure that the lifting beam is lowered to its lowest position.

Grab onto the handle (C) (Fig. 17), lift it up in a horizontal position and push it back towards

the device.

Grab onto the handle (D) (Fig. 18), now you can control / push the wheel dolly (Fig 19).

Fig. 17

Maintenance:

All moving parts must be inspected, cleaned and lubricated once a month. If there is rust on the

device, it has to be cleaned of, and added some rust protection. Ensure that locking and rolls on

the device, all are intact and in order. Be sure that the lock rings, nuts, chains, bolts and axles are

intact and in order. If the unit is repaired, this must be done by someone with experience / skilled in

hydraulics. If any parts of the device are changed, these must be replaced with original parts. If the

device has been defective it has to be inspected by a person experienced / skilled in hydraulics.

There must be performed an annual inspection, the machine must be serviced by skilled personnel

so that the above means are tested and any problems fixed.

Oil:

Oil Reservoir: Contains 0.95 litters.

Use only hydraulic oil AWS22

Do not use brake fluid, engine oil or other liquids!

Disposal:

Drain the device for oil in a responsible manner. Dispose of the oil and other parts to an approved

recipient of the waste.

SN/2011-06-21

Fig. 18

Fig. 19