- ページ 6
ヒーター dreo DR-HSH003のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。dreo DR-HSH003 12 ページ。 Ptc fan heater
ページを印刷する
Control Panel
Remote Control
Note: All the functions can be achieved through the
buttons on the remote control.
Power Indicator
Temperature-
Mode / Heat level
Oscillation
8
Power ON/OFF
Temperature+
Mute / Unmute
Timer
Operations and Functions
Place the heater on a firm, level surface free from obstructions,
and at least 3ft. (0.9m) away from any wall or combustible
material. Plug into an appropriate voltage AC 120V outlet, The
unit will enter standby mode with a beep and power indicator
on red. Your heater is ready for use now.
Power ON/OFF
The RED indicator (
switched on.
Press
on the heater / remote control once to turn
the heater on with default settings: Power indicator on
red, default temperature "95°F" & high heat level "HI"
on LED display.
Press
once again to turn the heater off. If the heater
is operating, it will take 15 seconds for the heater to shut
off, with the countdown time shown on the display.
Mode / Heat Level Settings
When the unit is on, repeatedly press
/ remote control to cycle through High (HI) ->Low (LO) ->
ECO -> High (HI) modes.
ECO Mode
When ECO mode is turned on, the heater will adjust the
working mode (High or Low) automatically based on the
ambient temperature.
You can also adjust the set temperature by pressing
or
.
When the set temperature is reached, the heater will
stop working.
"ECO"
will light up on the display when ECO Mode is
selected.
Mute / Unmute
Hold
on the heater for 3 seconds, OR press the
button on the remote control to turn the buzzer on or
off. The "HI","LO" and "ECO" will flash once along with a
beep sound if Mute/Unmute is enabled.
) lights up when the heater is
on the heater
9