- ページ 14

ホブ Electrolux U01317 EHG 678WのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Electrolux U01317 EHG 678W 20 ページ。 Electrolux gas hob instruction booklet

Building In

Building over a cupboard or drawer

If the hob is to be installed above a cupboard or

drawer it will be necessary to fit a heat resistant board

below the base of the hob on the underside of the

work surface.

ON/OFF SWITCH

FLEX

OUTLET

FO 0763

Building over a kitchen unit with door

Proper arrangements must be taken in designing the

furniture unit, in order to avoid any contact with the

bottom of the hob which can be heated when it is

operated. The recommended solution is shown in

diagram 3.

The panel fitted under the hob ("a") should be easily

removable to allow easy access if technical assistance

is needed. The space behind the kitchen unit ("b") can

be used for connections.

Fitting the hob to the worktop

Before fitting the hob into the cut out, an adhesive

sealing gasket supplied with the hob must be fitted to

the edge of the cut out. It is essential that no gaps are

left in this seal in order to prevent spillage near the

hob seeping into the cabinet below.

1) Place the sealing gasket all around the edge

of the cut out.

2) Place the hob into the cut out and secure it by

means of the relevant fixing clamps and

screws, as shown in the diagram.

It is also recommended to carry out the electrical

connection to the hob as shown in diagrams 1 and 2.

ON/OFF SWITCH

FLEX

OUTLET

FO 0764

FO 0402

FO 1013

Dimensions are given in mm.

a) Sealing gasket