- ページ 5

換気フード Electrolux 36" CeramicのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Electrolux 36" Ceramic 8 ページ。 30” and 36” free-standing range hood
Electrolux 36" Ceramic にも：取扱説明書 (26 ページ), 取付説明書 (7 ページ), 設置・使用・お手入れマニュアル (22 ページ), 取付説明書 (25 ページ)

ページを印刷する

GAS COOKTOP INSTALLATION INSTRUCTIONS

Wall Outlet Location

(10.2 cm)

Recommended

area for 120V

grounded

outlet on rear

wall.

NOTE: If an

outlet is not

available, have

one installed by

a qualified

technician.

Figure 4

Provide an Adequate Gas Supply

This cooktop is designed to operate on natural gas at 4"

(10.2 cm) of manifold pressure only.

A pressure regulator is connected in series with the

manifold on the cooktop and must remain in series with

the supply line.

For proper operation, the maximum inlet pressure to

the regulator must be no more than 14" (35.6 cm) of

water column (W.C.) pressure.

For checking the regulator, the inlet pressure must be at

least 1"(2.5 cm) (or 2.5 kPa) greater than the regulator

manifold pressure setting. The regulator is set for 4"

(10.2 cm) of manifold pressure, the inlet pressure must

be at least 5" (12.7 cm).

The gas supply line to the range should be 1/2" (1.3 cm)

or 3/4" (1.9 cm) pipe.

LP/Propane Gas Conversion

This appliance can be used with Natural gas or LP/

Propane gas. It is shipped from the factory for use with

natural gas.

A kit for converting to LP gas is supplied with your

cooktop. The kit is marked "FOR LP/PROPANE GAS

CONVERSION".

(For 36" Models with 6 Sealed Burners)

(12.7 cm)

16"

CENTRE

(40.6 cm)

LINE

OF UNIT

CENTRE

LINE

OF UNIT

The conversion must be performed by a qualified service

technician in accordance with the kit instructions and all

local codes and requirements. Failure to follow

instructions could result in serious injury or property

damage. The qualified agency performing this work

assumes responsibility for the conversion.

Failure to make the appropriate

conversion can result in personal injury and property

damage.

Important:

Remove all packing material and

literature from cooktop before connecting gas and

electrical supply to cooktop.

Install Pressure Regulator

Install the pressure regulator with the arrow on the

regulator pointing up toward the unit in a position where

you can reach the access cap.

Do not make the connection too tight.

The regulator is die cast. Overtightening may crack the

regulator resulting in a gas leak and possible fire or

explosion.

All connections must be wrench-tightened

Assemble the flexible connector from the gas supply pipe

to the pressure regulator in the following order:

1. manual shutoff valve

2. 1/2" (1.3 cm) nipple

3. 1/2" (1.3 cm) flare union adapter

4. flexible connector

5. 1/2" (1.3 cm) flare union adapter

6. 1/2" (1.3 cm) nipple

7. pressure regulator

Use pipe-joint compound made for use with Natural and

LP/Propane gas to seal all gas connections. If flexible

connectors are used, be certain connectors are not

kinked.

Figure 5