- ページ 12

換気フード Electrolux CH 600のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Electrolux CH 600 13 ページ。 Electrolux cooker hood
Electrolux CH 600 にも：ユーザーマニュアル (12 ページ), ユーザーマニュアル (14 ページ), ユーザーマニュアル (12 ページ)

ページを印刷する

Installation

Wall unit mounting - Fig. 8

• Put the template onto the wall (1) and drill two Ø12mm holes (2).

• Fit two hooks (3) on the drilled holes.

• Remove the metal filters (4) and hang the hood on the hooks and adjust the position of the hood using the two

screws on the bottom of the hooks (5).

• Mark 2/4 points (6). Remove the hood and drill 2/4 Ø8mm holes on the marked points.

Fit 2/4 Ø8mm wall dowels, Hang again the hood and fix the hood definitively with 2/4 screws 5X45 (7).

• Fix the chimney support (8) with two screws 5 x 45 mm and two wall dowels on the wall close to the ceiling.

• For exhausting version: Fit the connection ring (S) on the top of the hood with two screws Ø 3,5 x 6,5 mm

(9S) then fit an axhausting pipe long enough to reach the outside (10S).

For recycling version: Fix definitively the deflector (K) on the top of the hood with two screws Ø 3,5 x 6,5

mm (9K).

• Prepare the electric connection (11) (see relative chapter).

• Fit the chimney (12) and fix it on

the chimney support with two

screws 3,0 x 9 mm (13).

The lower part of the chimney

must be slided down and inserted

on the housing on the upper part of

the hood (14).

• Fit the two grids (15) on both

sides of the chimney.

Fig. 8