- ページ 20

換気フード Electrolux CH 910のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Electrolux CH 910 28 ページ。 Stylish stainless steel chimney hood
Electrolux CH 910 にも：取扱説明書 (21 ページ)

ページを印刷する

20 electrolux

Fitting the Wall Brackets

Wall marking:

• Draw a vertical line on the supporting

wall up to the ceiling, or as high as

practical, at the centre of the area in

which the hood will be installed.

• Draw a horizontal line at 650 mm

above the hob.

• Place bracket 7.2.1 on the wall as

shown about 1-2 mm from the ceiling

or upper limit aligning the centre

(notch) with the vertical reference line.

• Mark the wall at the centres of the

holes in the bracket.

• Place bracket 7.2.1 on the wall as

shown at X mm below the ﬁ rst bracket

(X = height of the upper chimney

section supplied), aligning the centre

(notch) with the vertical line.

• Mark the wall at the centres of the

holes in the bracket.

• Mark a reference point as indicated

at 116 mm from the vertical reference

line and 320 mm above the horizontal

reference line.

INSTALLING THE COOKER HOOD

• Repeat this operation on the other

side.

• Drill ø 8 mm holes at all the centre

points marked.

• Insert the wall plugs (not supplied) in

the holes.

• Fix the lower bracket 7.2.1 using the

two screws (not supplied).

• Fix the upper bracket 7.2.1 and the

air outlet connection support 7.3

together using the two screws (not

supplied).

• Insert the two screws (not supplied) in

the hood body ﬁ xing holes, leaving a

gap of 5-6 mm between the wall and

the head of the screw.

Note: If the hood is to be installed

onto a hollow construction or

plaster or partition board wall

then special ﬁ xing screws will be

required (not supplied).