- ページ 10

コンピュータ・ハードウェア Dresser Wayne HyperPIB SeriesのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Dresser Wayne HyperPIB Series 18 ページ。 Peripheral interface board

ページを印刷する

2.3 Returning Damaged Components

Parts or components returned to the factory under warranty or for repair are subject to damage if not

packaged properly. Complete the following steps to return parts or components to the factory.

1. Place electronic components in an anti-static bag and in the original shipping cartons for return

shipment to the factory.

If original shipping cartons are not available use a sturdy cardboard container and suitable

NOTE:

packing materials such as anti-static polyethylene foam or bubble pack, to ensure the component is

firmly packed.

2. Include a Return Parts Tag with the defective component describing the particular problem with

the part.

3. Make sure that adequate insurance is provided when returning parts to the factory.

If the parts or components arrive at our factory in a damaged condition and it is

WARNING:

determined that the damage is a direct result of inadequate or improper packaging, the damage will

not be covered under the original warranty and the customer or distributor will be held responsible for

the cost of repairs necessary to correct or replace the damaged parts.

2.4 HyperPIB Installation

2.4.1 Required Equipment

Verify the following items are available before attempting to install the HyperPIB.

April 2003

Installation

Part No. 917404-001 Rev. B

2-4