- ページ 17

換気フード Electrolux DI 8610のPDF 操作および設置マニュアルをオンラインで閲覧またはダウンロードできます。Electrolux DI 8610 24 ページ。 Cooker hood
Electrolux DI 8610 にも：操作およびインストール手順 (20 ページ)

Installation - Fig. 6-7-8

Expansion plugs are provided to secure the hood to most types of

ceilings. However, a qualified technician must verify suitability of the

materials in accordance with the type of ceiling. The ceiling must be

strong enough to take the weight of the hood.

During electrical connection ensure the power supply is disconnected

at the domestic mains switch.

• Adjust extension of the hood support structure, as the final height of

the hood depends on this, and remember that with installation

completed the hood must be at least 60 cm above the hob top for

electric cookers and 75 cm for gas or mixed fuel cookers.

• Fix the two sections of the structure using 8 screws (2).

• Place the ceiling hole diagram directly above the hob top (3 - the

centre of the diagram must match the centre of the hob top and the

edges must be parallel to the sides of the hob top – the side of the

diagram with the wording FRONT corresponds to the control panel

side). Prepare the electrical connection.

• Drill as shown (6 holes for 6 wall plugs – 4 plugs for fixture), screw

the outer screws leaving a space of about 1 cm. between the screw

head and the ceiling (4).

• Fit an exhaust pipe inside the support (5) and connect it to the motor

compartment connection ring (exhaust pipe and fixing brackets are

not supplied).

• Hook the frame onto the 4 screws (6 - see also step 4).

CAUTION! The side of the support with connection box corresponds

to the side of the control panel with hood assembled.

• Tighten the 4 screws (7).

• Insert and tighten another 2 screws in the remaining free holes (8)

for secure fixing.

• Carry out the electrical connection (9) to the mains power supply,

only turn on the power supply upon completion of assembly.

• Hook the hood onto the support (10) , ensuring it fits properly – to

hook the hood onto the support partially tighten 4 screws (see also

step 12).

• Secure the hood to the support using two screws (11); this will also

help centre the two sections.

• Tighten the 4 screws securing the support to the hood (12).