- ページ 10
換気フード Electrolux E36WV60PPSのPDF 設置・使用・お手入れマニュアルをオンラインで閲覧またはダウンロードできます。Electrolux E36WV60PPS 12 ページ。 30"(76.2 cm) and 36"(91.4 cm) range hood
Electrolux E36WV60PPS にも： 設置・使用・お手入れマニュアル (12 ページ)
ページを印刷するElectrical connection
WARNING
Electrical Shock Hazard
Warning: Turn off power circuit at the service
panel before wiring this unit.
120 VAC, 15 or 20 Amp circuit required.
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FI-I-rED WITH AN ELECTRICAL
JUNCTION BOX WITH 3 WIRES, ONE OF WHICH
(GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE. TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW
WIRE MUST BE CONNECTED TO THE GROUND-
ING WIRE IN YOUR HOME ELECTRICAL SYSTEM,
AND IT MUST UNDER NO CIRCUMSTANCES BE
CUT OR REMOVED.
Failure to do so can result in death or electrical
shock.
•
Remove the knockout and the Junction box
cover and install the conduit connector (cULus
listed) in junction box.
•
Run 3 wires; black, white and green, according
to the National Electrical Code and local codes
and ordinances, in 1A"conduit from service
panel to junction box.
•
Connect black wire from service panel to black
or red in junction box, white to white and green
to green-yellow.
•
Close and secure junction box cover.
Final installation step
•
Replace the 2 lateral supports.
•
Replace filters.
•
Check operation of the hood.
If range hood does not operate:
•
Check that the circuit breaker is not tripped or
the house fuse blown.
•
Disconnect power supply.
•
Check that wiring is correct.
Keep your Installation Instructions and Use and Care
Guide close to range hood for easy reference.
@
1. Blower control switch
4.
Grease filter Handle
2.
Light control switch
5.
Grease filter
3.
Lamp housings
6.
Serial/Rating
plate
(see page 6)
Controls
Use the high suction speed in cases of concentrated
kitchen vapours. It is recommended that the cooker
hood suction is switched on for 5 minutes prior to
cooking and to leave in operation during cooking and
for another 15 minutes approximately after terminating
cooking.
Description of control panel
light
fan
1
2
1. Light Control
•
Turn the light switch (1) to the right 1 position for
HIGH.
•
Turn the light switch (1) to the right 2 positions for
LOW.
•
To turn the lights OFF,rotate the light switch (1) to
the left to the OFF position.
2. Fan Control
The fan has 4 speeds.
*
Rotate the fan switch (2) to the right to turn the fan
ON. Continue to rotate the switch to the desired
fan speed.
°
To turn the fan OFF, rotate the fan speed (2) switch
to the left to the OFF position.