- ページ 5

換気フード Electrolux E:Line ERCE90ASのPDF インストールとユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Electrolux E:Line ERCE90AS 10 ページ。

ページを印刷する

Installation

Mounting the hood body

63mm

170mm

120mm

243mm

1. Using a spirit level mark a vertical centre line on the wall

where the hood is to be positioned, and a horizontal line

at the hood base position (refer Mounting the hood body).

NOTE: The height of the underside of the hood body must

be a minimum of 600mm above an electric cooktop &

650mm above a gas cook top and a maximum height of

800mm (refer to table below).

Distance from hood base to top of hob

hob type

gas

electric

* If the instructions of the hob specify a greater distance than the

minimum above, this shall be the minimum height for installation

2. Mark the location for the four (4) key-hole fixings points,

two at 243mm, and two at 363mm above the marked

position of the hood base (refer Mounting the hood body).

3. Fix four (4) suitable screws (to support a total weight of

40kg) into the wall at the positions marked in step 2 to

allow the body of the hood to be hung on the wall. Leave a

3-4mm gap between the face of the screw and the surface

of the wall.

NOTE: Screw head must be between 7mm and 11mm

diameter, with screw thread diameter to be less than

5.5mm to suit key-hole slots.Total hood weight is 40kg.

4. Hang the body of the hood on the wall using the screws

attached in step 3. To secure the hood body, use two

(2) suitable screws and fix the top-edge of the motor

housing to the wall.

ceiling

top flue fixing holes

for recirculating mode

bottom fixing holes for

T-piece assembly

190mm

top edge of

motor housing

key hole fixings

for wall mounting

minimum*

maximum

650mm

800mm

600mm

800mm

Depending on the preferred installation/ducting mode,

follow step 5a or 5b below:

5. a) Recirculating Mode: Using the centre line, secure the

flue fixing bracket to the wall with suitable screws, so

that the location of the fixing holes are 63mm from

the ceiling. Attach the recirculating T-piece to the flue

fixing bracket using two M5x12mm screws (supplied).

Secure bottom of T-piece assembly to wall using

suitable screws.

5. b) Ducted Mode: Continue the centre line to the ceiling.

Mark a line on the ceiling 14mm away from the wall.

Locate the back edge of the flue cover mounting

bracket on this line and centre. Screw the bracket to

the ceiling using suitable screws.

hood

base

top

NOTE: Flue pipe shown is not included - must be

of hob

purchased separately.

important

In recirculating mode, you must use carbon filters to

eliminate cooking smells (Carbon filter model no. EFF72).

NOTE: To ensure best performance of the rangehood use of

straight ducting is recommended. The use of bends should

be avoided. Rigid flexible ducting is suitable, although loose

flexible ducting is unacceptable.

All ducting must be fire retardant.

6. Connect an internal flue pipe (not included) between the

fan outlet to the inlet of the T-piece/flue cover mounting

bracket (depending on ducting mode).

NOTE: Before installing outer flue cover, ensure the power

cord is connected to a suitable powerpoint.

electrolux e:line rangehood installation 3

150mm