en Installation instructions
WARNING ‒ Risk of electric shock!
If the insulation of the power cord is dam-
aged, this is dangerous.
▶ Never let the power cord come into contact
with hot appliance parts or heat sources.
▶ Never let the power cord come into contact
with sharp points or edges.
▶ Never kink, crush or modify the power
cord.
WARNING ‒ Risk of injury!
The drawer may open suddenly during trans-
port.
▶ Transport the appliance in such a way that
the drawer does not accidentally open.
Sharp-edged parts may be accessible during
installation.
▶ Wear protective gloves.
ATTENTION!
When the door is opened, the appliance may
tip over.
▶ Above the appliance, provide a fixed inter-
mediate floor in the fitted unit.
▶ When combined with an oven, provide a
fixed intermediate floor above the oven.
21.6 Installation
Fitted units
This is where you can find information about safe in-
stallation.
ATTENTION!
Covering the ventilation slots and air intake openings
causes the appliance to overheat.
Do not cover ventilation slots and air intake open-
▶
ings.
If the appliance is installed behind a decorative panel,
this may cause it to overheat.
Do not install the appliance behind a decorative
▶
panel.
When the door is opened, the appliance may tip over.
Above the appliance, provide a fixed intermediate
▶
floor in the fitted unit.
When combined with an oven, provide a fixed inter-
▶
mediate floor above the oven.
The built-in unit must not have a rear panel behind the
appliance.
Combining with other appliances
You can combine the warming drawer with a maximum
of one more appliance from the same appliance series.
No intermediate floor is required between the appli-
ances.
When installing appliances under an oven, combi-
steam oven or steam oven, no tilt protection is re-
quired.
When installing under the fully automatic coffee ma-
chine, install the tilt protection for the fully automatic
coffee machine.
18
For the following combinations, install tilt protection on
the warming drawer:
¡ Warming drawer separately, including when in-
stalling below an intermediate floor
¡ Warming drawer underneath a microwave
¡ Warming drawer underneath a hob
¡ Warming drawer with warming drawer, at least on
the upper appliance
¡ Warming drawer with accessories drawer, at least
on the upper appliance
¡ Warming drawer with vacuuming drawer, at least on
the upper appliance
Suitable tilt protection can be obtained from customer
service, on our website or in the online shop.
→ "Fitting tilt protection", Page 18
Fitting tilt protection
Suitable tilt protection (order number: 12039458) can
be obtained from customer service, on our website or
in the online shop.
Measure a clearance of 518 mm from the front
1.
edge of the unit and mark it on both sides in the fit-
ted unit.
Screw the two brackets into the elongated hole on
2.
the mark.
Place the appliance on a flat surface.
3.
ページを印刷する