- ページ 44

冷蔵庫 Bosch 8 SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Bosch 8 Series 48 ページ。 Combi steam oven
Bosch 8 Series にも： 取付説明書 (21 ページ), 組み立て説明書 (4 ページ), 取付・使用説明書 (16 ページ), クイック・リファレンス・マニュアル (2 ページ), ユーザーマニュアルと設置手順 (44 ページ), はじめに (7 ページ), 取扱説明書 (32 ページ), ユーザーマニュアルと設置手順 (32 ページ), 取扱説明書 (12 ページ), ユーザーマニュアルと設置手順 (24 ページ), ユーザーマニュアル (28 ページ), ユーザーマニュアルと設置手順 (28 ページ), 取付・使用説明書 (20 ページ), ユーザーマニュアルと設置手順 (44 ページ), 取扱説明書 (12 ページ), ユーザーマニュアルと設置手順 (40 ページ), ユーザーマニュアルと設置手順 (32 ページ), ご利用案内 (20 ページ)

ページを印刷する
Bosch 8 Series 取扱説明書
en Installation and connection

Drinking water connection

Fasten the drinking water connection
1.
to the tap according
to the installation instructions using
the enclosed parts.
Ensure that the drinking water
connection is not kinked, crushed
or twisted.
When replacing the appliance,
2.
always use a new water supply
hose.
Water pressure:
at least 0.05 MPa (0.5 bar), maximum 1
MPa (10 bar).
At a higher water pressure:
connect pressure-reducing valve ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
cold water.
Hot water:
Maximum temperature 60 °C.
44

Warm water connection *

* depending on the features of your
i o n
W a r m w a t e r c o n n e c t
dishwasher
The dishwasher can be connected
to cold or hot water up to max. 60 °C.
Connection to hot water is
recommended if the hot water can be
supplied by energetically favourable
means and from a suitable installation,
e.g. solar heating system with
circulation line. This will save energy
and time. The "Hot water" setting allows
you to adjust your dishwasher optimally
to operation with hot water. It is
recommended to have a water
temperature (temperature of the
incoming water) of at least 40 °C and
no more than 60 °C. It is not
recommended to connect the appliance
to hot water if the water is supplied from
an electric boiler.
To change the setting:
Open the door.
1.
Switch on ON/OFF switch (.
2.
Press Info button {8 for 3
3.
seconds until the following text is
indicated on the display window at
the top @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
Keep pressing the button > )" until
4.
water connection appears of the
display window at the top @.
Make the setting with setting buttons
5.
+ -P.
Press and hold the Info button {
6.
8 for 3 seconds.
The chosen setting has now been
stored.