- ページ 2

芝生とガーデン用品 Atlantic Eco-BloxのPDF 組立マニュアルをオンラインで閲覧またはダウンロードできます。Atlantic Eco-Blox 3 ページ。
Atlantic Eco-Blox にも：製品マニュアル (17 ページ), 製品マニュアル (16 ページ), 製品マニュアル (17 ページ)

ページを印刷する

1. Begin assembly by placing one (1) large

panel in a vertical position with the 27¾"

long side on the ground. When assembly

is complete this panel will become the

bottom of the Eco-Blox.

2. Locate the 14½" side of one (1) of

the four (4) small support panels. Insert

the slide lock tabs of the 14½" side into

the receiving channel at one end of the

bottom panel. Holding the bottom panel

in one hand, push down on the support

panel until it 'clicks' into position. The

support panel should be centered on

bottom panel.

3. Repeat Step 2 for the three (3) remaining

support panels.

4. Rotate the Eco-Blox so the bottom panel

lays flat on the ground and the support

panels are facing upright.

5. Install the side panel by inserting the

slide lock tabs of all four (4) support

panels into the receiving channels.

Starting at one end, push down on the

side panel above each receiving

channel until they click into position.

The top of the side panel should be flush

with the tops of the support panels when

fully installed.

27¾"

16"

14½"

6. Repeat this step for the other side panel.

7. Lay the EcoBlox on its side.

8. Install the top panel by repeating

the same steps used for the sides.

9. To complete the assembly, rotate the

Eco-Blox so that the bottom panel is flat on

the ground and the top panel is facing up.

In this position, the top panel is supported

by the sides as well as the center support

panels. EcoBlox must always be installed

in this position. Improper installation will

reduce the structural integrity of the unit

and may cause the Eco-Blox to fail.