- ページ 3

芝生とガーデン用品 Atlantic PGPSM-74045のPDF 製品マニュアルをオンラインで閲覧またはダウンロードできます。Atlantic PGPSM-74045 12 ページ。

ページを印刷する

Step 5:

Connect one tie-down to each of the four

fiberglass poles. The tie-downs should be

attached above the second metal connector

on each pole. Hold both ends of one tie-down

in one hand and find the center with the other

hand. Wrap the rope around the pole and insert

the ends through the loop, forming a slip knot.

(Figure 5a) Pull the knot tight. (Figure 5b) Repeat

this step for the other three poles (Remember:

tie-downs should be attached above the second

metal connector on each pole. Attaching the

tie-down above the connector will keep the knot

from sliding down the pole.)

Step 6:

Cover the Pond & Garden Protector with the net.

(Figure 6)

Step 7:

Next install two net clips on each pole.

Clips should be evenly spaced, two per pole.

Begin by installing one clip closest to the Center

Pole Receptor under the first metal connector.

Pull the excess slack out of the net before you

attach the clip. Wrap the clip around the pole and

squeeze the clip to fasten (Figure 7). Repeat this

step by securing the second clip on the pole at

the bottom of the lower metal connector.

Securing the clips on the bottoms of the metal

connectors keep them from sliding up.

Step 8:

Place Pond & Garden Protector over the water

garden.

Step 9:

Secure the Pond & Garden Protector in place

using the tie-downs and the four large tent

stakes (Figure 9). Working from a short side of the

rectangular base, pull one of the tie-downs from

the pole on the left and one from the pole on the

right, towards the ground in the middle of the

two poles. Drive a tent stake into the ground, pull

the excess slack out of the tie-downs and attach

the tie-down to the tent stake. Move to the

opposite side and repeat. Once the two ends

have been secured, the two remaining sides

should be secured in the same fashion.

Figure 5a

Figure 5b

Figure 6

Figure 7

Figure 9